10436-57-4Relevant articles and documents
Fungicidal Activity of S-Esters of Thiocarboxylic Acids as Antimicrobial Additives to Petroleum Products
Aliev,Belovezhets,Oparina
, p. 99 - 105 (2019)
Abstract: A variety of aliphatic and aromatic S-esters of thiocarboxylic acids have been tested for antimicrobial activity. The relationship between the chemical structure of the compounds R1SC(O)R2 and their toxicity for microorganisms has been revealed, and the effect of various functional groups on the antimicrobial properties has been shown. The cooling lubricant IKhP-45E with S-aryl thioacetate additives has been tested. It has been shown that the additives used (0.25–0.5 wt %) inhibit the growth of all the studied microorganisms; however, their activity with respect to fungi is higher. The introduction of S-aryl thioacetates provides the resistance of these oils to microbiological deterioration to retain the physicochemical properties for a long period of time.
Thioesters as Bifunctional Reagents for 2-Naphthylamine Sulfuracylation
Xiao, Fuhong,Yuan, Shanshan,Wang, Dahan,Liu, Saiwen,Huang, Huawen,Deng, Guo-Jun
supporting information, p. 3331 - 3336 (2019/06/13)
An efficient and convenient strategy for the preparation of diaryl sulfides via a Fe-promoted direct sulfuracylation of 2-naphthylamine using thioesters as bifunctional reagents is described. This synthetic strategy features high chemoselectivity, good substrate scope and functional group tolerance. (Figure presented.).
Efficient Cu-catalyzed base-free C-S coupling under conventional and microwave heating. A simple access to S-heterocycles and sulfides
Soria-Castro, Silvia M.,Penenory, Alicia B.
supporting information, p. 467 - 475 (2013/05/08)
S-aryl thioacetates can be prepared by reaction of inexpensive potassium thioacetate with both electron-rich and electron-poor aryl iodides under a base-free copper/ligand catalytic system. CuI as copper source affords S-aryl thioacetates in good to excellent yields, by using 1,10-phenanthroline as a ligand in toluene at 100°C after 24 h. Under microwave irradiation the time was drastically reduced to 2 h. Both procedures are simple and involve a low-cost catalytic system. This methodology was also applied to the "one-pot" synthesis of target heterocycles, such as 3H-benzo[c][1,2]dithiol-3-one and 2-methylbenzothiazole, alkyl aryl sulfides, diaryl disulfides and asymmetric diaryl sulfides in good yields.