35822-46-9Relevant articles and documents
Effects of oxygen on formation of PCB and PCDD/F on extracted fly ash in the presence of carbon and cupric salt
Pekarek,Grabic,Marklund,Puncochar,Ullrich
, p. 777 - 782 (2007/10/03)
The effect of oxygen-nitrogen atmosphere (N2 + 10%O2, N2 + 1%O2 and 99.999% N2) on the formation of PCB, PCDD and PCDF by the de novo synthetic reactions in the system consisting of extracted fly ash
Dioxins from thermal and metallurgical processes: Recent studies for the iron and steel industry
Buekens,Stieglitz,Hell,Huang,Segers
, p. 729 - 735 (2007/10/03)
In thermal metallurgical processes such as iron ore sintering and metal smelting operations, large flows of off-gases are generated. Mainly due to residue recycling in such processes, chlorine and volatile organics are always present in the feed. As a consequence of de novo formation, the off-gases from such processes typically contain dioxins in the range 0.3-30 ng I-TEQ/Nm3. So far there are only very few studies about the mechanisms of dioxin formation and destruction in these metallurgical processes. In an European Union (EU) research project Minimization of dioxins in thermal industrial processes: mechanisms, monitoring and abatement (MINIDIP) , integrated iron and steel plant has been selected as one of the industrial sectors for further investigation. A large number of particulate samples (feed, belt siftings, electrofilter) were collected from the iron ore sintering installations from various steel plants and analyzed for their organochlorocompound contents. Measurable amounts of PCDD/F, PCBz, PCB were found for all samples. The various parameters influencing their de novo synthesis activity were also evaluated in laboratory experiments, and such activity was found to be moderate for samples from the ore sinter belt, but extremely high for some ESP dusts. Fine dust is active in a wide range of temperatures starting at 200°C and declining above 450°C; the optimal temperature for de novo synthesis was found to be around 350°C; some inhibitors, such as triethanolamine, may reduce de novo activity by 50%, and lowering the O2 concentration in the gas stream leads to a much lower amount of PCDD/F formation. On the basis of their relative mass, typical operating conditions and specific activity of the different samples, the regions in the sintering plant where de novo synthesis may take place were tentatively established.
PCDD/F inhibition by prior addition of urea to the solid fuel in laboratory experiments and results statistical evaluation
Samaras,Blumenstock,Lenoir,Schramm,Kettrup
, p. 737 - 743 (2007/10/03)
The objectives of this work were to study the effect of urea addition to the fuel before the combustion on the suppression of PCDD/F emissions, to examine the influence of urea to PCDD/F isomer patterns by employing statistical analysis techniques and to determine the most effective method of urea addition. Urea in the form of powder and as an aqueous solution was mixed with RDF and the fuel mixtures were incinerated in a lab-scale reactor at 1000°C. PCDD/F emitted during combustion experiments were collected in a quartz wool filter downstream the reactor unit. Analysis and quantification of PCDD/F showed that urea significantly affected PCDD/F emissions. Combustion of RDF containing 10% w/w urea resulted in PCDD/F emissions lower than 8 I-TEQ ng/g RDF, while the corresponding average value from single RDF combustion was 17 I-TEQ ng/g RDF. The PCDD/F prevention capacity of urea was independent from the method of urea addition to the fuel, as similar results were obtained after the addition of urea in the solid and in the aqueous phases. Results assessment by statistical methods showed that isomer patterns remained almost stable and were not affected by the method of urea addition.
