Welcome to LookChem.com Sign In|Join Free

CAS

  • or

578-58-5

Post Buying Request

578-58-5 Suppliers

Recommended suppliersmore

  • Product
  • FOB Price
  • Min.Order
  • Supply Ability
  • Supplier
  • Contact Supplier

578-58-5 Usage

Chemical Properties

o-Methylanisole has a pungent, warm, floral odor with earthy, walnut undertones. It has a sweet, fruity, nut-like flavor at low levels.

Physical properties

clear colorless to light yellow liquid. soluble in alcohol and ether, insoluble in water.

Occurrence

Reported found in starfruit, mastic gum oil and rooibus tea (Aspalathus linearis).

Uses

The catalytic system of disubstituted aromatics was optimized for the 2-methylanisole reduction by a proper choice of the amine/Rh ratio which should be high enough to stabilize very small colloidal rhodium particles and low enough to avoid deactivation. The total synthesis of (±)-heliannuol D and its epimer has been completed in 9 steps and 12% overall yield from 2-methylanisole. The thermal activation of 2-methylanisole (60°C) by the Ir (III) complex TpMe2Ir (C6H5) 2 (N2)(1; TpMe2= hydrotris (3, 5-dimethylpyrazolyl) borate) yielded a mixture of hydride complexes. The total synthesis of the phenolic sesquiterpene mutisianthol has been accomplished in 12 steps from the readily available 2-methylanisole. The catalytic system was optimized for the 2-methylanisole reduction by a proper choice of the amine/Rh ratio which should be high enough to stabilize very small colloidal rhodium particles and low enough to avoid deactivation.

Definition

ChEBI: 2-methylanisole is a monomethoxybenzene that is o-cresol in which phenolic hydroxy group has been converted to the corresponding methyl ether. A 'green' solvent (b.p. 171°C) and food flavour ingredient, it is found in mastic oils, virgin olive oils and frankincense. It has a role as a polar aprotic solvent and a flavouring agent. It is a monomethoxybenzene, a volatile organic compound and a member of toluenes. It derives from an o-cresol.

Preparation

2-Methylanisole is synthesized by methylation of o-cresol using dimethylsulfate in caustic soda at 40°C.synthesis of 2-methylanisole: Make sodium hydroxide into a 20% solution, stir and mix with o-cresol, cool to below 10°C, and slowly add dimethyl sulfate dropwise. After the addition was completed, the temperature was raised to 40 °C for 20 min, and then reacted with 100 °C for 12 h. Then the reactant was washed with water until neutral, water was removed, distilled, and the fraction at 171°C was collected to obtain the finished product of 2-methylanisole.

Aroma threshold values

Detection: 600 ppb. Aroma characteristics at 1.0%: naphthyl, camphoreous, phenolic and woody with a salicylate nuance.

Taste threshold values

Taste characteristics at 5.0 ppm: camphoreous, earthy, woody and alicylate with minty, spicy nuances.

General Description

2-Methylanisole is found in mastic oils, virgin olive oils and frankincense. It is a monomethoxybenzene and acts as an intermediate for the preparation of compounds with methylhydroquinone core.

Flammability and Explosibility

Flammable

Check Digit Verification of cas no

The CAS Registry Mumber 578-58-5 includes 6 digits separated into 3 groups by hyphens. The first part of the number,starting from the left, has 3 digits, 5,7 and 8 respectively; the second part has 2 digits, 5 and 8 respectively.
Calculate Digit Verification of CAS Registry Number 578-58:
(5*5)+(4*7)+(3*8)+(2*5)+(1*8)=95
95 % 10 = 5
So 578-58-5 is a valid CAS Registry Number.
InChI:InChI=1/3C8H10O/c1-7-3-5-8(9-2)6-4-7;1-7-4-3-5-8(6-7)9-2;1-7-5-3-4-6-8(7)9-2/h3*3-6H,1-2H3

578-58-5 Well-known Company Product Price

  • Brand
  • (Code)Product description
  • CAS number
  • Packaging
  • Price
  • Detail
  • Alfa Aesar

  • (A13897)  2-Methylanisole, 99%   

  • 578-58-5

  • 50g

  • 563.0CNY

  • Detail
  • Alfa Aesar

  • (A13897)  2-Methylanisole, 99%   

  • 578-58-5

  • 250g

  • 1274.0CNY

  • Detail
  • Alfa Aesar

  • (A13897)  2-Methylanisole, 99%   

  • 578-58-5

  • 1000g

  • 4320.0CNY

  • Detail

578-58-5SDS

SAFETY DATA SHEETS

According to Globally Harmonized System of Classification and Labelling of Chemicals (GHS) - Sixth revised edition

Version: 1.0

Creation Date: Aug 12, 2017

Revision Date: Aug 12, 2017

1.Identification

1.1 GHS Product identifier

Product name 2-Methylanisole

1.2 Other means of identification

Product number -
Other names 1-methoxy-2-methylbenzene

1.3 Recommended use of the chemical and restrictions on use

Identified uses For industry use only. Food additives -> Flavoring Agents
Uses advised against no data available

1.4 Supplier's details

1.5 Emergency phone number

Emergency phone number -
Service hours Monday to Friday, 9am-5pm (Standard time zone: UTC/GMT +8 hours).

More Details:578-58-5 SDS

578-58-5Relevant articles and documents

Solvolysis of o-methylbenzenediazonium tetrafluoroborate in acidic methanol-water mixtures. Further evidence for nucleophilic attack on a solvent separated aryl cation

Pazo-Llorente,Sarabia-Rodriguez,Gonzalez-Romero,Bravo-Diaz

, p. 531 - 538 (1999)

Rate constants for dediazoniation product formation and arenediazonium ion loss and product yields of solvolysis of o-methylbenzenediazonium tetrafluoroborate in acidic methanol-water mixtures at T = 35 °C are reported. Observed rate constants for diazonium ion loss and product formation are the same, increasing about 45% ongoing from water to methanol, and are not affected by added electrolytes like HCl, NaCl, and CuCl2. Only three dediazoniation products are detected, o-cresol, o-chlorotoluene, and o-anisole. All data are consistent with a rate-determining step formation of an aryl cation that reacts immediately with available nucleophiles. The selectivity of the reaction toward nucleophiles, S, which can be is low and essentially constant upon changing solvent composition, suggesting that the nucleophilic attack takes place on a solvent separated aryl cation.

Impact of oxygen vacancies in Ni supported mixed oxide catalysts on anisole hydrodeoxygenation

Ali, Hadi,Kansal, Sushil Kumar,Lauwaert, Jeroen,Saravanamurugan, Shunmugavel,Thybaut, Joris W.,Vandevyvere, Tom

, (2022/03/02)

The hydrodeoxygenation (HDO) activity of anisole has been investigated over Ni catalysts on mixed metal oxide supports containing Nb–Zr and Ti–Zr in 1:1 and 1:4 ratios. XRD patterns indicate the incorporation of Ti (or Nb) into the ZrO2 framewo

Trialkylammonium salt degradation: Implications for methylation and cross-coupling

Assante, Michele,Baillie, Sharon E.,Juba, Vanessa,Leach, Andrew G.,McKinney, David,Reid, Marc,Washington, Jack B.,Yan, Chunhui

, p. 6949 - 6963 (2021/06/02)

Trialkylammonium (most notably N,N,N-trimethylanilinium) salts are known to display dual reactivity through both the aryl group and the N-methyl groups. These salts have thus been widely applied in cross-coupling, aryl etherification, fluorine radiolabelling, phase-transfer catalysis, supramolecular recognition, polymer design, and (more recently) methylation. However, their application as electrophilic methylating reagents remains somewhat underexplored, and an understanding of their arylation versus methylation reactivities is lacking. This study presents a mechanistic degradation analysis of N,N,N-trimethylanilinium salts and highlights the implications for synthetic applications of this important class of salts. Kinetic degradation studies, in both solid and solution phases, have delivered insights into the physical and chemical parameters affecting anilinium salt stability. 1H NMR kinetic analysis of salt degradation has evidenced thermal degradation to methyl iodide and the parent aniline, consistent with a closed-shell SN2-centred degradative pathway, and methyl iodide being the key reactive species in applied methylation procedures. Furthermore, the effect of halide and non-nucleophilic counterions on salt degradation has been investigated, along with deuterium isotope and solvent effects. New mechanistic insights have enabled the investigation of the use of trimethylanilinium salts in O-methylation and in improved cross-coupling strategies. Finally, detailed computational studies have helped highlight limitations in the current state-of-the-art of solvation modelling of reaction in which the bulk medium undergoes experimentally observable changes over the reaction timecourse. This journal is

Ceramic boron carbonitrides for unlocking organic halides with visible light

Yuan, Tao,Zheng, Meifang,Antonietti, Markus,Wang, Xinchen

, p. 6323 - 6332 (2021/05/19)

Photochemistry provides a sustainable pathway for organic transformations by inducing radical intermediates from substrates through electron transfer process. However, progress is limited by heterogeneous photocatalysts that are required to be efficient, stable, and inexpensive for long-term operation with easy recyclability and product separation. Here, we report that boron carbonitride (BCN) ceramics are such a system and can reduce organic halides, including (het)aryl and alkyl halides, with visible light irradiation. Cross-coupling of halides to afford new C-H, C-C, and C-S bonds can proceed at ambient reaction conditions. Hydrogen, (het)aryl, and sulfonyl groups were introduced into the arenes and heteroarenes at the designed positions by means of mesolytic C-X (carbon-halogen) bond cleavage in the absence of any metal-based catalysts or ligands. BCN can be used not only for half reactions, like reduction reactions with a sacrificial agent, but also redox reactions through oxidative and reductive interfacial electron transfer. The BCN photocatalyst shows tolerance to different substituents and conserved activity after five recycles. The apparent metal-free system opens new opportunities for a wide range of organic catalysts using light energy and sustainable materials, which are metal-free, inexpensive and stable. This journal is

Post a RFQ

Enter 15 to 2000 letters.Word count: 0 letters

Attach files(File Format: Jpeg, Jpg, Gif, Png, PDF, PPT, Zip, Rar,Word or Excel Maximum File Size: 3MB)

1

What can I do for you?
Get Best Price

Get Best Price for 578-58-5