90-42-6Relevant articles and documents
The Silicon-Hydrogen Exchange Reaction: A Catalytic σ-Bond Metathesis Approach to the Enantioselective Synthesis of Enol Silanes
Zhou, Hui,Bae, Han Yong,Leutzsch, Markus,Kennemur, Jennifer L.,Bécart, Diane,List, Benjamin
supporting information, p. 13695 - 13700 (2020/08/24)
The use of chiral enol silanes in fundamental transformations such as Mukaiyama aldol, Michael, and Mannich reactions as well as Saegusa-Ito dehydrogenations has enabled the chemical synthesis of enantiopure natural products and valuable pharmaceuticals. However, accessing these intermediates in high enantiopurity has generally required the use of either stoichiometric chiral precursors or stoichiometric chiral reagents. We now describe a catalytic approach in which strongly acidic and confined imidodiphosphorimidates (IDPi) catalyze highly enantioselective interconversions of ketones and enol silanes. These "silicon-hydrogen exchange reactions"enable access to enantiopure enol silanes via tautomerizing σ-bond metatheses, either in a deprotosilylative desymmetrization of ketones with allyl silanes as the silicon source or in a protodesilylative kinetic resolution of racemic enol silanes with a carboxylic acid as the silyl acceptor.
Effective hydrodeoxygenation of dibenzofuran by a bimetallic catalyst in water
Dong, Peng,Lu, Guo-Ping,Cai, Chun
, p. 1605 - 1609 (2016/02/19)
Effective hydrodeoxygenation (HDO) of dibenzofuran (DBF) catalyzed by a bimetallic nickel/platinum (Ni/Pt) catalyst in water was demonstrated at 200 °C and 1.2 MPa hydrogen (H2) pressure. The bimetallic catalysts prepared by a wet chemical method exhibit prominent activity that overcomes the limitations of use of a single Ni or Pt metal catalyst. The yield of HDO products can be up to 90%. Reaction results indicate that the conversion of DBF was affected by the reaction temperature and H2 pressure. The deoxygenation selectivity was strongly dependent on reaction temperature. The reaction pathway is also proposed.
Cu/Mg/Al/Zr non-noble metal catalysts for o-phenylphenol synthesis
Zeng, Yongping,Zhang, Tianchi,Xu, Yueyang,Hu, Peili,Ye, Ting,Jia, Zhehua,Ju, Shengui
, p. 6737 - 6746 (2016/02/03)
Cu/Mg/Al/Zr hydrotalcite-like precursors with Zr4+:(Al3+ + Zr4+) atomic ratios between 0 and 1 were prepared by co-precipitation methods. The precursors were analyzed using X-ray diffraction (XRD), scanning electron microscopy (SEM), thermogravimetric (TG) analysis and Fourier transform infrared spectroscopy (FT-IR). The results confirmed that well-defined layered double hydroxides (LDH) can be synthesized when the added Zr content is less than 0.25 in terms of Zr4+/(Al3+ + Zr4+) atomic ratio. The catalysts of Cu/Zn/Al/Zr mixed oxides can be obtained via thermal decomposition of hydroxide precursors, and can be used in dehydrogenation of 2-(1-cyclohexenyl) cyclohexanone (CHCH) to ortho-phenylphenol (OPP). Copper particles inside the catalyst act as active sites for dehydrogenation. Transmission electron microscopy (TEM), XRD, N2O chemisorption and N2 adsorption-desorption were performed to investigate the effect of Zr content on determining the copper particle size. Based on the catalytic performance test, it was concluded that the conversion of CHCH depends on the copper particle size of these catalysts.
