371-40-4Relevant articles and documents
-
Fidler et al.
, p. 4014,4016 (1961)
-
Dihydro-2H-thiopyran-3(4H)-one-1,1-dioxide–a new cyclic ketomethylenic reagent for the Dimroth-type 1,2,3-triazole synthesis
Pokhodylo, Nazariy T.,Tupychak, Mykola A.,Palchykov, Vitalii A.
, p. 1835 - 1844 (2020)
A series of 1,5,6,7-tetrahydrothiopyrano[2,3-d][1,2,3]triazole 4,4-dioxides, new triazole-based bicyclic ring system, were prepared via base-mediated click reaction of organic azides with the readily available dihydro-2H-thiopyran-3(4H)-one-1,1-dioxide. The reaction proceeded at room temperature in 5-12 h with catalysis by base-solvent system K2CO3/DMSO. High purity products were isolated by simple filtration and no formation of side products was observed. The key structure was confirmed by an X-ray study.
Nickel Boride Catalyzed Reductions of Nitro Compounds and Azides: Nanocellulose-Supported Catalysts in Tandem Reactions
Proietti, Giampiero,Prathap, Kaniraj Jeya,Ye, Xinchen,Olsson, Richard T.,Dinér, Peter
, p. 133 - 146 (2021/11/04)
Nickel boride catalyst prepared in situ from NiCl2 and sodium borohydride allowed, in the presence of an aqueous solution of TEMPO-oxidized nanocellulose (0.01 wt%), the reduction of a wide range of nitroarenes and aliphatic nitro compounds. Here we describe how the modified nanocellulose has a stabilizing effect on the catalyst that enables low loading of the nickel salt pre-catalyst. Ni-B prepared in situ from a methanolic solution was also used to develop a greener and facile reduction of organic azides, offering a substantially lowered catalyst loading with respect to reported methods in the literature. Both aromatic and aliphatic azides were reduced, and the protocol is compatible with a one-pot Boc-protection of the obtained amine yielding the corresponding carbamates. Finally, bacterial crystalline nanocellulose was chosen as a support for the Ni-B catalyst to allow an easy recovery step of the catalyst and its recyclability for new reduction cycles.
Room-temperature copper-catalyzed electrophilic amination of arylcadmium iodides with ketoximes
Korkmaz, Adem
, p. 3119 - 3125 (2021/05/10)
We started our study by preparation two ketoximes. Later, there were studies to reveal these ketoximes' effects in the electrophilic amination reaction with organocadmium reagents. Primarily, it was observed that arylcadmium iodides could not be reacted with ketoximes at room temperature in the absence of a catalyst. CuCN was a suitable catalyst for this electrophilic amination reaction of arylcadmium iodides and allowed the preparation of functionalized aniline derivatives in good yields under mild reaction conditions. We obtained the results indicated that the yield of primary arylamines was strongly dependent on the steric and electronic effects of organocadmium reagent and amination agent. In the case of both amination reagents, meta-substituted arylamines were obtained in higher yields than para-substituted arylamines. We observed that acetone O-(4-chlorophenylsulfonyl)oxime, 1, as an aminating agent, was more successful than acetone O-(2-Naphthylsulfonyl)oxime, 2, in the synthesis of functionalized arylamines by electrophilic amination of corresponding aryl cadmium iodides. In this method, there is no cadmium release to the environment.
Aluminum Metal-Organic Framework-Ligated Single-Site Nickel(II)-Hydride for Heterogeneous Chemoselective Catalysis
Antil, Neha,Kumar, Ajay,Akhtar, Naved,Newar, Rajashree,Begum, Wahida,Dwivedi, Ashutosh,Manna, Kuntal
, p. 3943 - 3957 (2021/04/12)
The development of chemoselective and heterogeneous earth-abundant metal catalysts is essential for environmentally friendly chemical synthesis. We report a highly efficient, chemoselective, and reusable single-site nickel(II) hydride catalyst based on robust and porous aluminum metal-organic frameworks (MOFs) (DUT-5) for hydrogenation of nitro and nitrile compounds to the corresponding amines and hydrogenolysis of aryl ethers under mild conditions. The nickel-hydride catalyst was prepared by the metalation of aluminum hydroxide secondary building units (SBUs) of DUT-5 having the formula of Al(μ2-OH)(bpdc) (bpdc = 4,4′-biphenyldicarboxylate) with NiBr2 followed by a reaction with NaEt3BH. DUT-5-NiH has a broad substrate scope with excellent functional group tolerance in the hydrogenation of aromatic and aliphatic nitro and nitrile compounds under 1 bar H2 and could be recycled and reused at least 10 times. By changing the reaction conditions of the hydrogenation of nitriles, symmetric or unsymmetric secondary amines were also afforded selectively. The experimental and computational studies suggested reversible nitrile coordination to nickel followed by 1,2-insertion of coordinated nitrile into the nickel-hydride bond occurring in the turnover-limiting step. In addition, DUT-5-NiH is also an active catalyst for chemoselective hydrogenolysis of carbon-oxygen bonds in aryl ethers to afford hydrocarbons under atmospheric hydrogen in the absence of any base, which is important for the generation of fuels from biomass. This work highlights the potential of MOF-based single-site earth-abundant metal catalysts for practical and eco-friendly production of chemical feedstocks and biofuels.