5888-52-8Relevant articles and documents
Comparative evaluation of new synergists containing a butynyl-type synergophore group and piperonyl butoxide derivatives
Pap, Laszlo,Arvai, Geza,Bertok, Bela,Ribai, Zsuzsanna Kuruczne,Bakonyvari, Ildiko
, p. 186 - 190 (2001)
Cross-substituted derivatives of piperonyl butoxide (PBO) and MB-599 (proposed common name: verbutin) were synthesized and investigated as carbofuran and permethrin synergists against housefly, Musca domestica L. The majority of PBO and MB-599 derivatives were significantly more potent synergists for carbofuran than for permethrin. PBO, the most important representative of this series was not the most potent synergist for carbofuran or for permethrin. Cleavage of the methylenedioxy ring of methylenedioxyphenyl (MDP) polyether compounds resulted in complete loss of synergistic activity with both insecticides, but it could be restored or even improved by incorporating an alkynyl ether moiety into the molecule. The improved synergistic activity was found to be closely associated with the 2-butynyloxymethyl side-chain, suggesting that this can be regarded as a characteristic synergophore group. MB-599, one of the most promising compounds bearing this group showed considerably higher activity with carbofuran (synergist ratio, SR=37.8) than with PBO (SR=6.4). There was no significant difference between synergistic activities of MB-599 (SR=4.6) and PBO (SR=4) for permethrin.
Ligand-enabled and magnesium-activated hydrogenation with earth-abundant cobalt catalysts
Han, Bo,Jiao, Hongmei,Ma, Haojie,Wang, Jijiang,Zhang, Miaomiao,Zhang, Yuqi
, p. 39934 - 39939 (2021/12/31)
Replacing expensive noble metals like Pt, Pd, Ir, Ru, and Rh with inexpensive earth-abundant metals like cobalt (Co) is attracting wider research interest in catalysis. Cobalt catalysts are now undergoing a renaissance in hydrogenation reactions. Herein, we describe a hydrogenation method for polycyclic aromatic hydrocarbons (PAHs) and olefins with a magnesium-activated earth-abundant Co catalyst. When diketimine was used as a ligand, simple and inexpensive metal salts of CoBr2in combination with magnesium showed high catalytic activity in the site-selective hydrogenation of challenging PAHs under mild conditions. Co-catalyzed hydrogenation enabled the reduction of two side aromatics of PAHs. A wide range of PAHs can be hydrogenated in a site-selective manner, which provides a cost-effective, clean, and selective strategy to prepare partially reduced polycyclic hydrocarbon motifs that are otherwise difficult to prepare by common methods. The use of well-defined diketimine-ligated Co complexes as precatalysts for selective hydrogenation of PAHs and olefins is also demonstrated.
Eco-friendly preparation of ultrathin biomass-derived Ni3S2-doped carbon nanosheets for selective hydrogenolysis of lignin model compounds in the absence of hydrogen
Chen, Changzhou,Jiang, Jianchun,Li, Jing,Liu, Peng,Wu, Dichao,Xia, Haihong,Zhou, Minghao
, p. 3090 - 3103 (2021/05/07)
Lignin is an abundant source of aromatics, and the depolymerization of lignin provides significant potential for producing high-value chemicals. Selective hydrogenolysis of the C-O ether bond in lignin is an important strategy for the production of fuels and chemical feedstocks. In our study, catalytic hydrogenolysis of lignin model compounds (β-O-4, α-O-4 and 4-O-5 model compounds) over Ni3S2-CS catalysts was investigated. Hence, an array of 2D carbon nanostructure Ni3S2-CSs-X-Yderived catalysts were produced using different compositions at different temperatures (X= 0 mg, 0.2 mg, 0.4 mg, 0.6 mg, and 0.8 mg; Y = 600 °C, 700 °C, 800 °C, and 900 °C) were prepared and applied for hydrogenolysis of lignin model compounds and depolymerization of alkaline lignin. The highest conversion of lignin model compounds (β-O-4 model compound) was up to 100% and the yield of the obtained corresponding ethylbenzene and phenol could achieve 92% and 86%, respectively, over the optimal Ni3S2-CSs-0.4-700 catalyst in iPrOH at 260 °C without external H2. The 2D carbon nanostructure catalysts performed a good dispersion on the surface of the carbon nanosheets, which facilitated the cleavage of the lignin ether bonds. The physicochemical characterization studies were carried out by means of XRD, SEM, TEM, H2-TPR, NH3-TPD, Raman and XPS analyses. Based on the optimal reaction conditions (260 °C, 4 h, 2.0 MPa N2), various model compounds (β-O-4, α-O-4 and 4-O-5 model compounds) could also be effectively hydrotreated to produce the corresponding aromatic products. Furthermore, the optimal Ni3S2-CSs-0.4-700 catalyst could be carried out in the next five consecutive cycle experiments with a slight decrease in the transformation of lignin model compounds.
