information Related products Suppliers

<span xmlns="" style="font-weight:bold;">METHYL ETHER of PROPYLENE GLYCOL (</span>α)

MATERIAL SAFETY DATA SHEET
91P

WESTERN AUTOMOTIVE FINISHES EMERGENCY TELEPHONE NO. DATE OF PREPARATION
101 PROSPECT AVE. N.W. (216) 566-2917 2 - D E C - 9 1 (PROP 65 INFO ADDED 12/95)

CLEVELAND, OH 44115 INFORMATION TELEPHONE NO.
Automotive Finishes

(216) 566-2902 ?1991, Western Automotive Finishes
TM
E-BASE Non-Isocyanate Clear Coat ACR-B/W4
Reducers
????? S E C T I O N I I ????? ACGIH OSHA Vapor W2005 W2015 WU4575 WU6590 WU85100
Isocyanate Free IsocyanateFree Reducer Reducer Reducer
CAS No. HAZARDOUS INGREDIENT TLV PEL Units Pressure
(percent by weight) Clear Coat Clear Coat Activator Fast Medium Slow
(mm Hg)

64742-89-8 Lt. Aliphatic HC Solvent. 100 100 PPM 53.0 6
?? 100 100
108-88-3 Toluene. PPM 22.0 10 23 19 35
<150> <150 >
?? 100 100
100-41-4 Ethylbenzene. PPM 7.1 4 6 3 2
<125> <125 >
?? 100 100
1330-20-7 Xylene. PPM 5.9 23 36 15 12
<150> <150 >
64742-94-5 Heavy Aromatic Naphtha 50 PPM 0.1 15
??
71-36-3 1-Butanol C50 C50 PPM (Skin) 5.5 11 24

1320-67-8 Methoxypropanol 100 PPM 10.9 4
??
111-76-2 2-Butoxyethanol 25 25 PPM (Skin) 0.6 4 9
??
112-34-5 2-(2-Butoxyethoxy)-ethanol Not Established 0.06 8 9
?? 50 50
108-10-1 Methyl Isobutyl Ketone. PPM 16.0 14
<75 > <75 >
141-78-6 Ethyl Acetate 400 400 PPM 86.0 42 20 10
200 200
109-60-4 n-Propyl Acetate. PPM 23.0 15
<250> <250 >
150 150
123-86-4 n-Butyl Acetate. PPM 10.0 20 10
<200> <200 >
??
112-07-2 2-Butoxyethyl Acetate. 50 PPM 1.0 11 15

108-65-6 1-Methoxy-2-Propanol Acetate Not Established 1.8 11

Weight per Gallon (lbs.) 7.72 7.55 7.15 7.40 7.34

VOC - Total Volatile Organic Compounds (lbs./gal.) 5.01 6.30 7.15 7.40 7.34

VOC - Less Water and exempt Solvents (lbs./gal.) 5.01 6.30 7.15 7.40 7.34

Photochemically Reactive Yes Yes Yes Yes Yes

Flash Point (??F) 45 79 25 25 25

DOL Storage Category 1B 1C 1B 1B 1B

HMIS? (NFPA) Rating (health - fire - reactivity) 230 230 230 230 230

PAINT-SAFE? Personal Protection J3 J3 J3 J3 J3
??
Ingredient subject to the reporting requirements of the Superfund Amendments and Reauthorization Act (SARA) Section 313, 40 CFR 372.65 C

IV-4
E-BASETM Non-Isocyanate Clear Coat ACR-B/W4
Section VII ?? SPILL OR LEAK PROCEDURES
Section III ?? PHYSICAL DATA
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLE PRODUCT WEIGHT EVAPORATION RATE
?? See TABLE ?? Slower than Ether
Remove all sources of ignition. Ventilate and remove with inert absorbent.
SPECIFIC GRAVITY VAPOR DENSITY
?? 0.86-0.93 ?? Heavier than Air
WASTE DISPOSAL METHO BOILING RANGE MELTING POINT
?? 163-448 ??F ?? N.A.
Waste from this product may be hazardous as defined under the Resource Conservation and
VOLATILE VOLUME SOLUBILITY IN WATE ?? 70-100 % ?? N.A.
??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????? Recovery Act (RCRA) 40 CFR 261. Waste must be tested for ignitability to determine the
Section IV ?? FIRE AND EXPLOSION HAZARD DATA applicable EPA hazardous waste numbers.
??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????? Incinerate in approved facility. Do not incinerate closed container. Dispose of in
accordance with Federal, State, and Local regulations regarding pollution.
FLAMMABILITY CLASSIFICATION FLASH POINT LEL UEL
See TABLE 0.5 13.1
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
RED LABEL ?? Flammable, Flash below 100 F
Section VIII ?? PROTECTION INFORMATION
EXTINGUISHING MEDIA
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
Carbon Dioxide, Dry Chemical, Foam
PRECAUTIONS TO BE TAKEN IN USE
UNUSUAL FIRE AND EXPLOSION HAZARDS
Use only with adequate ventilation. Avoid breathing vapor and spray mist. Avoid contact
Keep containers tightly closed. Isolate from heat, electrical equipment, sparks, and open
with skin and eyes. Wash hands after using.
flame. Closed containers may explode when exposed to extreme heat. Application to hot
This coating may contain materials classified as nuisance particulates (listed ??as Dust?? in
surfaces requires special precautions. During emergency conditions overexposure to
Section II) which may be present at hazardous levels only during sanding or abrading of the
decomposition products may cause a health hazard. Symptoms may not be immediately apparent.
dried film. If no specific dusts are listed in Section II, the applicable limits for nuisance
Obtain medical attention.
dusts are ACGIH TLV 10 mg./m3 (total dust), OSHA PEL 15 mg./m3 (total dust), 5 mg./m3
SPECIAL FIRE FIGHTING PROCEDURES
(respirable fraction).
Full protective equipment including self-contained breathing apparatus should be used.
VENTILATION
Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be
Local exhaust preferable. General exhaust acceptable if the exposure to materials in
used to cool closed containers to prevent pressure build-up and possible autoignition or
Section II is maintained below applicable exposure limits. Refer to OSHA Standards 1910.94,
explosion when exposed to extreme heat.
??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????? 1910.107, 1910.108.
Section V ?? HEALTH HAZARD DATA RESPIRATORY PROTECTION
??????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????? If personal exposure cannot be controlled below applicable limits by ventilation, wear
a properly fitted organic vapor/particulate respirator approed by NIOSH/MSHA for protection
ROUTES OF EXPOSURE
against materials in Section II.
Exposure may be by INHALATION and/or SKIN or EYE contact, depending on conditions of use.
When sanding or abrading the dried film, wear a dust/mist respirator approved by NIOSH/MSHA
Alcohols and Acetates can be absorbed through the skin. To minimize exposure, follow
for dust which may be generated from these products, underlying paint, or the abrasive.
recommendations for proper use, ventilation, and personal protective equipment.
PROTECTIVE GLOVES
ACUTE Health Hazards
Wear gloves which are recommended by glove supplier for protection against materials in
EFFECTS OF OVEREXPOSURE
Section II.
Irritation of eyes, skin and respiratory system. May cause nervous system depression.
EYE PROTECTION
Extreme overexposure may result in unconsciousness and possibly death.
Wear safety spectacles with unperforated sideshields.
SIGNS AND SYMPTOMS OF OVEREXPOSURE
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
Headache, dizziness, nausea, and loss of coordination are indications of excessive exposure
Section IX ?? PRECAUTIONS
to vapors or spray mists.
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
Redness and itching or burning sensation may indicate eye or excessive skin exposure.
DOL STORAGE CATEGORY ?? See TABLE
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
None known.
Contents are FLAMMABLE. Keep away from heat, sparks, and open flame.
EMERGENCY AND FIRST AID PROCEDURES
During use and until all vapors are gone: Keep area ventilated - Do not smoke -
If INHALED: If any breathing problems occur during use, LEAVE THE AREA and get fresh air.
Extinguish all flames, pilot lights, and heaters - Turn off stoves, electric tools and
If problems remain or occur later, IMMEDIATELY get medical attention.
appliances, and any other sources of ignition.
If on SKIN: Wash affected area thoroughly with soap and water.
Consult NFPA Code. Use approved Bonding and Grounding procedures.
Remove contaminated clothing and launder before re-use.
Keep container closed when not in use. Transfer only to approved containers with complete
If in EYES: Flush eyes with large amounts of water for 15 minutes. Get medical attention.
and appropriate labeling. Do not take internally. Keep out of the reach of children.
If SWALLOWED: Get medical attention.
OTHER PRECAUTIONS
CHRONIC Health Hazards
This product may be mixed with other components before use. Before opening the packages,
No ingredient in these products is an IARC, NTP, or OSHA listed carcinogen.
READ AND FOLLOW WARNING LABELS ON ALL COMPONENTS.
Prolonged overexposure to solvent ingredients in Section II may cause adverse effects to
Intentional misuse by deliberately concentrating and inhaling the contents can be harmful
the liver, urinary, blood forming, cardio-vascular, and reproductive systems.
or fatal.
Reports have associated repeated and prolonged overexposure to solvents with permanent brain
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
and nervous system damage.
Section X ?? OTHER REGULATORY INFORMATION
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
Section VI ?? REACTIVITY DATA
CALIFORNIA PROPOSITION 65
???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
WARNING: These products contain chemicals known to the State of California to cause cancer
STABILITY ?? Stable
and birth defects or other reproductive harm.
INCOMPATIBILITY
None known.
HAZARDOUS DECOMPOSITION PRODUCTS
By fire: Carbon Dioxide, Carbon Monoxide
HAZARDOUS POLYMERIZATION ?? Will Not Occur

The above information pertains to this product as currently formulated, and is based on
the information available at this time. Addition of reducers or other additives to this
product may substantially alter the composition and hazards of the product. Since conditions
of use are outside our control, we make no warranties, express or implied, and assume no
liability in connection with any use of this information.

IV-4

;