1,6-Hexanediamine,2,2,4-trimethyl-

MATERIAL SAFETY DATA SHEET

PRODUCT NAME: Epoxy.com #672 ??B?? HMIS CODES: H F R P
310C
SECTION 1: MANUFACTURER IDENTIFICATION
MANUFACTURER'S NAME: Epoxy Systems, Inc.
ADDRESS: 20774 West Pennsylvania Ave
Dunnellon, FL 34431
EMERGENCY NUMBER: 1-800-633-8253 DATE PRINTED: 03/31/08
INFORMATION NUMBER: 1-352-489-1666 PREPARER: Katey Fontaine
SECTION 2: HAZARDOUS INGREDIENTS
ACGIH
OSHA PEL TLV WT % CARCINOGEN
HAZARDOUS COMPONENTS CAS NUMBE Benzyl Alcohol 100-51-6 NE NE 20-40 NO
Trimethylhexanediamine 3236-53-1 NE NE 1-10 NO
Isophoronediamine 2855-13-2 NE NE 20-40 NO
Substances listed are present in concentration of 1% or greater, or 0.1% if
cited as a potential carcinogen in the OSHA hazards communication standard.
Where proprietary ingredient is listed, the identity is available as provided
in 29 CFR 1910-1200.
NE - Not Established
SECTION 3: PHYSICAL/CHEMICAL CHARACTERISTICS
BOILING POINT 414o F
VAPOR DENSITY NE
VAPOR PRESSURE NE
VOC 0.00
SOLUBILITY IN WATER <1% @ 77o F
APPEARANCE Low viscosity with sharp ammonia
odor
SPECIFIC GRAVITY (H20=1) 0.99
EVAPORATION RATE NE
SECTION 4: FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: >200o F
METHOD USED: Closed Cup
FLAMMABLE LIMITS IN AIR BY VOLUME LOWER: Not determined
UPPER: Not determined
EXTINGUISHING MEDIA: Foam, dry chemical, CO2
OSHA FLAMMABILITY CLASSIFICATION: Combustible liquid, Class III B
SPECIAL FIRE FIGHTING PROCEDURES: Wear positive pressure self contained
breathing equipment. Use water to cool containers exposed to fire.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Toxic fumes present when this material
involved in fire. Containers may rupture.
SECTION 5: REACTIVITY DATA
STABILITY: Normally Stable.
CONDITIONS TO AVOID: Contact with acids such as Hydrochloric or Sulfuric.
INCOMPATIBILITY (MATERIALS TO AVOID): Avoid strong oxidizing agents and
epoxy resins under uncontrolled conditions.
HAZARDOUS DECOMPOSITION OR BY-PRODUCTS: When exposed to fire, oxides of
Carbon and Nitrogen will be generated.
HAZARDOUS POLYMERIZATION: Will not occur.
SECTION 6: HEALTH HAZARD DATA
HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
INHALATION: Vapors can cause severe irritation of respiratory tract.
SKIN: Corrosive - Can cause burns to skin.
EYE: Vapors - Can cause irritation and burns to eyes.
INGESTION: Can cause severe damage to mouth and throat.
HEALTH HAZARDS (ACUTE AND CHRONIC):
CARCINOGENICITY:
NTP CARCINOGEN: NO IARC MONOGRAPHS: NO OSHA REGULATED: NO
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Skin contact may
aggrevate existing dermatitis (skin condition). Over exposure to vapor or
mist may aggrevate existing respiratory conditions such as asthma,
bronchitis, or fibrotic respiratory disease.
EMERGENCY AND FIRST AID PROCEDURES:
EYES: Flush immediately for 15 minutes with large amounts of potable
water. DO NOT attempt to neutralize with chemical agents. Get
immediate medical attention.
SKIN: Flush immediately for 15 minutes with potable water. DO NOT
attempt to neutralize with chemical agents. Remove contaminated
clothing. Launder before reuse. Discard contaminated shoes. Get
medical attention if swelling and/or irritation occurs.
INGESTION: Give water to dilute stomach contents. DO NOT induce
vomiting. If vomiting occurs, give fluids again. Get immediate
medical attention. Do not give anything by mouth to an unconscious or
convulsing person.
INHALATION: Remove to fresh air. Get medical attention if effects
persist.
OTHER INSTRUCTIONS: Swallowing this corrosive material may result in
severe ulceration, inflamation, and possible perforation of the upper
alimentary tract, with hemorrhage and fluid loss. Aspiration of this
product during induced emesis can result in severe lung injury. If
evacuation of stomach is necessary, use method least likely to cause
aspiration, such as gastric lavage after endotracheal intubation.
Contact a Poison Control Center for additional treatment information.
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Avoid contact.
Allow only personnel wearing goggles, neoprene or rubber gloves and
protective clothing to clean up spill. In confined areas a full face
respirator is recommended. Absorb spill with clay, diatomaceous earth or
other absorbent material. Place in disposal containers.
WASTE DISPOSAL METHOD: Dispose of in approved incinerator or an approved
landfill.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Avoid contact. Keep
containers tightly closed when not in use. Do not remove labels from
empty containers. If mixtures of Part B and Part A are allowed to remain
in the mixing container past the pot life deadline, heat and a strong
reaction will result.
OTHER PRECAUTIONS: none
SECTION 8: CONTROL MEASURES
RESPIRATORY PROTECTION: If vapor or mist is generated and the occupational
exposure limit is exceeded, use appropriate NIOSH/MSHA approved self
contained breathing equipment or a full face respirator.
SECTION 8: CONTROL MEASURES (CON'T)
VENTILATION: Mechanical ventilation required if TLV is expected to be
exceeded in confined areas.
PROTECTIVE GLOVES: Neoprene or natural rubber gloves
EYE PROTECTION: Chemical goggles
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Body covering clothes
WORK/HYGIENIC PRACTICES: Practice good industrial hygiene. Wash with soap
and water before eating, smoking, or using the restroom.
SECTION 9: REGULATORY INFORMATION
SARA TITLE III SECTION 313: Unless shown below, this product does not
contain the following toxic chemicals subject to the reporting
requirements of section 313 of the Emergency Planning and Community Right
to Know Act of 1986 and of 40 CFR 372:
CAS # Chemical Name Percent by Weight
None

PROP 65 (CARCINOGEN): Unless shown below, this product does not contain
chemicals known to the state of California to cause cancer.
CAS # Chemical Name Percent by Weight
None
PROP 65 (TERATOGENIC): Unless shown below, this product does not contain
chemicals known to the state of California to cause birth defects or other
reproductive harm.
CAS # Chemical Name Percent by Weight
None
PROP 65 (CARCINOGENIC & TERATOGENIC): Unless shown below, this product does
not contain chemicals known to the state of California to cause cancer or
birth defects or other reproductive harm.
CAS # Chemical Name Percent by Weight
None
HAZARDOUS WASTE INFORMATION: Unless shown below, this product is not a
hazardous waste according to definitions found in CFR-40.
STATE OF MICHIGAN CRITICAL MATERIALS: Unless shown below, this product does
not contain ingredients appearing on the State of Michigan Critical
Materials List.
CAS # Chemical Name Percent by Weight
None
D. O. T. PROPER SHIPPING NAME: Caustic Alkali Liquid, N.O.S. (Modified
Cycloaliphatic Amines); 8; UN1719; PG II
PROPER SHIPPING NAME: Caustic Alkali Liquid, N.O.S. (Modified Cycloaliphatic
Amines)
HAZARD CLASS: Class 8, Corrosive
UN/NA ID NUMBER: UN 1719
PACKING GROUP: II
SECTION 10: DISCLAIME Data and recommendations presented herein are based upon our and other
researchers and are believed to be accurate. The products discussed are
distributed without warranty (expressed or implied) and the customer shall
make his own determination of suitability for his particular purpose.

;

Recommended suppliers

Dayang Chem (Hangzhou) Co.,Ltd.

China (Mainland) Assessed Supplier

2,2,4-trimethylhexane-1,6-diamine

  • Assay:Industrial Grade,
  • Appearance:detailed in specifications
  • Package:according to the clients requirement
  • Storage:Store in dry, dark and ventilated place.
  • Transportation:by air or by ocean shipping
  • Application:An important raw material and intermediate used in Organic Synthesis, Pharmaceuticals
Contact Supplier

GIHI CHEMICALS CO.,LIMITED

China (Mainland) Assessed Supplier

2,2,4-trimethylhexane-1,6-diamine

  • Assay:Pharmaceutical grade,
  • Appearance:Powder
  • Package:According to customer requirements
  • Storage:dry and cool
  • Transportation:Air and sea transportation
  • Application:Pharmaceutical Industry
Contact Supplier

Henan Wentao Chemical Product Co., Ltd.

China (Mainland) Assessed Supplier

2,2,4-Trimethyl-1,6-hexanediamine

  • Assay:99%
  • Appearance:
  • Package:drum
  • Storage:
  • Transportation:By Sea/Air/DHL
  • Application:chemical
Contact Supplier

Chemlyte Solutions

China (Mainland) Assessed Supplier

2,2,4-Trimethyl-1,6-hexanediamine

  • Assay:99.0,
  • Appearance:liquid
  • Package:Grams, Kilograms
  • Storage:Store the container tightly closed in a dry, cool and well-ventilated place. Store apart from foodstuff containers or incompatible materials.
  • Transportation:According to customer request
  • Application:For R&D and commerical use
Contact Supplier

Hangzhou Johoo Chemical Co., Ltd

China (Mainland) Assessed Supplier

2,2,4-trimethylhexane-1,6-diamine

  • Assay:99% ,98%,Electron Grade ,
  • Appearance:Highest quality appearance
  • Package:25kgs/drum;200kg/drum;IBC TANK
  • Storage:Keep in dry and well ventilated warehouse, keep sealed
  • Transportation:By air and by sea
  • Application:Extremely good quality, widely used in Pharmaceutical Industry, Food Industry, agricultural industry etc.
Contact Supplier

About|Contact|Cas|Product Name|Molecular|Country|Encyclopedia

Message|New Cas|MSDS|Service|Advertisement|CAS DataBase|Article Data|Manufacturers | Chemical Catalog

©2008 LookChem.com,License: ICP

NO.:Zhejiang16009103

complaints:service@lookchem.com Desktop View