Stannane, tetrabromo-

1 - Product and Company Information

Product Name TIN(IV) BROMIDE, 99%
Product Number 215961
2 - Composition/Information on Ingredients

Product Name CAS # EC no Annex I
Index Number
STANNIC BROMIDE 7789-67-5 232-184-5 None

Formula SnBr4
Molecular Weight 438.33 AMU
Synonyms Stannic bromide * Tin perbromide * Tin
tetrabromide

3 - Hazards Identification

SPECIAL INDICATION OF HAZARDS TO HUMANS AND THE ENVIRONMENT
Reacts violently with water. Causes burns. Irritating to
respiratory system.


4 - First Aid Measures

AFTER INHALATION
If inhaled, remove to fresh air. If not breathing give
artificial respiration. If breathing is difficult, give oxygen.

AFTER EYE CONTACT
Assure adequate flushing of the eyes by separating the eyelids
with fingers.

AFTER INGESTION
If swallowed, wash out mouth with water provided person is
conscious. Call a physician.

5 - Fire Fighting Measures

EXTINGUISHING MEDIA
Suitable: Use extinguishing media appropriate to surrounding
fire conditions.
SPECIAL RISKS
Specific Hazard(s): Emits toxic fumes under fire conditions.

SPECIAL PROTECTIVE EQUIPMENT FOR FIREFIGHTERS
Wear self-contained breathing apparatus and protective clothing
to prevent contact with skin and eyes.

6 - Accidental Release Measures

PERSONAL PRECAUTION PROCEDURES TO BE FOLLOWED IN CASE OF LEAK OR SPILL
Evacuate area.

PROCEDURE(S) OF PERSONAL PRECAUTION(S)
Wear self-contained breathing apparatus, rubber boots, and heavy
rubber gloves.

METHODS FOR CLEANING UP
Sweep up, place in a bag and hold for waste disposal. Avoid
raising dust. Ventilate area and wash spill site after material
pickup is complete.

7 - Handling and Storage

HANDLING
Directions for Safe Handling: Do not breathe dust. Do not get in
eyes, on skin, on clothing. Avoid prolonged or repeated exposure.

STORAGE
Conditions of Storage: Keep tightly closed. Store in a cool dry
place.

SPECIAL REQUIREMENTS: Air and moisture sensitive.

8 - Exposure Controls / Personal Protection

ENGINEERING CONTROLS
Safety shower and eye bath. Use only in a chemical fume hood.

GENERAL HYGIENE MEASURES
Wash thoroughly after handling. Wash contaminated clothing before
reuse. Discard contaminated shoes.

EXPOSURE LIMITS - DENMARK
Source Type Value
OEL TWA 2 mg/m3

EXPOSURE LIMITS - UNITED KINGDOM
Source Type Value
OEL TWA 2MG(SN)/M3
OEL STEL 4 mg(Sn)/m3

PERSONAL PROTECTIVE EQUIPMENT
Special Protective Measures: Wear appropriate government approved
respirator, chemical-resistant gloves, safety goggles, other
protective clothing. Faceshield (8-inch minimum).

9 - Physical and Chemical Properties

Appearance Color: Colorless
Form: Crystals


Property Value At Temperature or Pressure

pH N/A
BP/BP Range 202 ??C 760 mmHg
MP/MP Range 31 ??C
Flash Point N/A
Flammability N/A
Autoignition Temp N/A
Oxidizing Properties N/A
Explosive Properties N/A
Explosion Limits N/A
Vapor Pressure N/A
SG/Density 3.34 g/cm3
Partition Coefficient N/A
Viscosity N/A
Vapor Density N/A
Saturated Vapor Conc. N/A
Evaporation Rate N/A
Bulk Density N/A
Decomposition Temp. N/A
Solvent Content N/A
Water Content N/A
Surface Tension N/A
Conductivity N/A
Miscellaneous Data N/A
Solubility N/A

10 - Stability and Reactivity

STABILITY
Conditions of Instability: May decompose on exposure to moist air
or water.
Materials to Avoid: Strong acids, Strong oxidizing agents.

HAZARDOUS DECOMPOSITION PRODUCTS
Hazardous Decomposition Products: Hydrogen bromide gas, Tin/tin
oxides.

11 - Toxicological Information

RTECS NUMBER: XP8300000

ACUTE TOXICITY

LD50
Intravenous
Mouse
18 MG/KG

SIGNS AND SYMPTOMS OF EXPOSURE
Material is extremely destructive to tissue of the mucous
membranes and upper respiratory tract, eyes, and skin.
Inhalation may result in spasm, inflammation and edema of the
larynxand bronchi, chemical pneumonitis, and pulmonary edema.
Symptoms of exposure may include burning sensation, coughing,
wheezing, laryngitis, shortness of breath, headache, nausea, and
vomiting. To the best of our knowledge, the chemical, physical,
and toxicological properties have not been thoroughly
investigated.

ROUTE OF EXPOSURE
Multiple Routes: Harmful if swallowed, inhaled, or absorbed

through skin.

12 - Ecological Information

No data available.

13 - Disposal Considerations

SUBSTANCE DISPOSAL
The material should be dissolved in: 1) water, 2) acid solution,
or 3) oxidized to a water-soluble state. Precipitate the material
as the sulfide, adjusting the pH of the solution to 7 to complete
precipitation. Filter the insolubles and dispose of them in a
hazardous waste site. Destroy any excess sulfide with sodium
hypochlorite. Neutralize the solution before flushing down the
drain. Observe all federal, state, and local environmental
regulations.

14 - Transport Information

RID/AD UN#: 3260
Class: 8
PG: II
Proper Shipping Name: Corrosive solid, acidic,
inorganic, n.o.s.

IMDG
UN#: 3260
Class: 8
PG: II
Proper Shipping Name: CORROSIVE SOLID, ACIDIC,
INORGANIC, N.O.S.
Marine Pollutant: No
Severe Marine Pollutant: No
Technical Name: Required

IATA
UN#: 3260
Class: 8
PG: II
Proper Shipping Name: Corrosive solid, acidic,
inorganic, n.o.s.
Inhalation Packing Group I: No
Technical Name: Required

15 - Regulatory Information

CLASSIFICATION AND LABELING ACCORDING TO EU DIRECTIVES
INDICATION OF DANGER: C
Corrosive.
R-PHRASES: 14 34 37
Reacts violently with water. Causes burns. Irritating to
respiratory system.
S-PHRASES: 7/8 26 36/37/39 45
Keep container tightly closed and dry. In case of contact with
eyes, rinse immediately with plenty of water and seek medical
advice. Wear suitable protective clothing, gloves, and eye/face
protection. In case of accident or if you feel unwell, seek
medical advice immediately (show the label where possible).

16 - Other Information

WARRANTY
The above information is believed to be correct but does not
purport to be all inclusive and shall be used only as a guide. The
information in this document is based on the present state of our
knowledge and is applicable to the product with regard to
appropriate safety precautions. It does not represent any
guarantee of the properties of the product. Sigma-Aldrich Inc.,
shall not be held liable for any damage resulting from handling or
from contact with the above product. See reverse side of invoice
or packing slip for additional terms and conditions of sale.
Copyright 2005 Sigma-Aldrich Co. License granted to make unlimited
paper copies for internal use only.

DISCLAIME For R&D use only. Not for drug, household or other uses.




;

Recommended suppliers

Dayang Chem (Hangzhou) Co.,Ltd.

China (Mainland) Assessed Supplier

Tin(IV) bromide

  • Assay:Industrial Grade,
  • Appearance:detailed see specifications
  • Package:according to the clients requirement
  • Storage:Store in dry, dark and ventilated place.
  • Transportation:by ocean shipping or clients requirement
  • Application:An important raw material and intermediate used in Organic Synthesis, Pharmaceuticals
Contact Supplier

Chemwill Asia Co., Ltd.

China (Mainland) Assessed Supplier

Stannic bromide

  • Assay:1,d,
  • Appearance:As per Certificate of analysis and our TDS, MSDS
  • Package:Export standard and according to the clients requirement
  • Storage:Store in dry, dark and ventilated place;ISO / Kosher /GMP licence commercial bulk capacity factory in China
  • Transportation:By AIR or by SEA GMP licence / US-FDA,South Korea-KFDA
  • Application:It is an important raw material and intermediate for chemical industry.
Contact Supplier

Hangzhou J&H Chemical Co., Ltd.

China (Mainland) Assessed Supplier

Stannane, tetrabromo-

  • Assay:98%min
  • Appearance:Off-white to light yellow powder
  • Package:According to the clients requirement.
  • Storage:Keep in cool place.
  • Transportation:
  • Application:Pharmaceutical intermediates
Contact Supplier

Hunan chemfish Pharmaceutical co.,Ltd

China (Mainland) Assessed Supplier

TIN(IV) BROMIDE

  • Assay:
  • Appearance:95%+
  • Package:R&D,Pilot run
  • Storage:
  • Transportation:per client require
  • Application:
Contact Supplier

Antimex Chemical Limied

China (Mainland) Assessed Supplier

Tin(IV) broMide

  • Assay:0.98
  • Appearance:Off white to slight yellow solid
  • Package:1L 5L 10L 25L bottle
  • Storage:Stored in shaded, cool and dry places
  • Transportation:Handle with cares to avoid damaging the packages. Protect them from sunshine or rain. We can send by Fedex, by ship or by plane according to international rules.
  • Application:pharma intermediate
Contact Supplier

About|Contact|Cas|Product Name|Molecular|Country|Encyclopedia

Message|New Cas|MSDS|Service|Advertisement|CAS DataBase|Article Data|Manufacturers | Chemical Catalog

©2008 LookChem.com,License: ICP

NO.:Zhejiang16009103

complaints:service@lookchem.com Desktop View