information Related products Suppliers

Almond,sweet, ext.

MATERIAL SAFETY DATA SHEET
____________________________________________________________________________________________________________________________

MANUFACTURER'S NAME: NATIONAL COATINGS CORPORATION
1201 CALLE SUERTE
CAMARILLO, CA 93012
www.nationalcoatings.com

EMERGENCY TELEPHONE: 800-423-9557

DATE OF LAST REVISION: 05/22/07

SECTION I - PRODUCT IDENTIFICATION

PRODUCT NUMBER: A101

PRODUCT NAME: CLEARSEAL

PRODUCT CLASS: Acrylic Primer

SECTION II - HAZARDOUS INGREDIENTS

None known at hazardous level.

SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS

APPEARANCE: Milky white liquid EVAPORATION RATE: Slower than ether
BOILING POINT: 212??F SPECIFIC GRAVITY: (water=1) 1.0-1.2
VAPOR DENSITY: Less than air % VOLATILE BY VOLUME: 74%

SECTION IV - REACTIVITY DATA

STABILITY: Stable

HAZARDOUS POLYMERIZATION: Will not occur

HAZARDOUS DECOMPOSITION PRODUCTS: Oxides of carbon, acrylic monomers

CONDITIONS TO AVOID: Keep from freezing

INCOMPATIBILITY: None reasonably foreseeable

SECTION V - FIRE & EXPLOSION HAZARD DATA

FLAMABILITY CLASSIFICATION: Not DOT Regulated
Flash Point - Non combustible
LEL - N/A

EXTINGUISHING MEDIA: N/A

UNUSUAL FIRE & EXPLOSIONS HAZARD: Material can splatter above 212??F
Polymer film can burn.

MSDS - A101 MATERIAL SAFETY DATA SHEET
____________________________________________________________________________________________________________________________

SPECIAL FIREFIGHTING PROCEDURES: For fires involving this material, do not enter any enclosed or confined space
without proper protective gear, including self-contained breathing apparatus to protect against the hazardous effects of the
normal products of combustion or oxygen deficiency.

SECTION VI - SAFE HANDLING & USE INFORMATION

RESPIRATORY PROTECTION: Wear suitable respirator (MSHA/NIOSH approved or equivalent) where
exposure limits are exceeded.

VENTILATION: Mechanical local exhaust ventilation at point of containment release.

PROTECTIVE GLOVES: Impervious for prolonged or repeated contact.

EYE PROTECTION: Chemical splash goggles (ANSI Z-87.1 or approved equivalent)

SECTION VII - HEALTH HAZARD DATA

EFFECTS OF OVER EXPOSURE:
?? INHALATION: Vapor or mist can cause irritation of the nose, throat and lungs.
?? EYE EXPOSURE: Slightly irritating to eyes with direct contact.
?? SKIN EXPOSURE: Irritating to skin with repeated or prolonged exposure.

EMERGENCY & FIRST AID PROCEDURES:
?? INHALATION: Move subject to fresh air.
?? EYE & SKIN CONTACT: Flush eyes with large amounts of water for at least 15 minutes. See a
physician if irritation persists. Wash affected skin areas with soap and water.
?? INGESTION: If swallowed, dilute by giving two glasses of water to drink. CALL A
PHYSICIAN IMMEDIATELY.

SECTION VIII - SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Keep spectators away. Floor may
be slippery, use care to avoid falling. Scoop or shovel solid material into a suitable container for recovery or
disposal. Keep spills out of municipal sewers and open bodies of water.

WASTE DISPOSAL METHODS: Disposal should be in accordance with Federal, state, and local regulations.

SECTION IX - SPECIAL PRECAUTIONS

PRECAUTIONS TO BE TAKEN IN HANDLING & STORAGE: Keep from freezing.

OTHER PRECAUTIONS: None

UNUSUAL FIRE & EXPLOSIONS HAZARD: Material can splatter above 212??F
Polymer film can burn.

MSDS - A101

? 2007 National Coatings Corporation. All Rights Reserved.

;