information Related products Suppliers

ANTIFOAM B

MATERIAL SAFETY DATA SHEET
FOR METALWORKING FLUI
SECTION I - PRODUCT IDENTIFICATION

Manufacturer: Desilube Technology, Inc. Information Phone: 610-792-9460
904 Breezewood Lane Emergency Phone: 215-368-2327
Lansdale, PA 19446 Prepared by: J.P. King
Date: July 1, 2007

Trade Name: DESIGREEN 215B
Synonyms: Metalworking Compound
D.O.T. Hazard Class: None
Proper Shipping Name: None

SECTION II - INGREDIENTS - HAZARD CLASSIFICATIONS

Components - Hazardous CAS No. % Comments

Alkyl C16-C18-Methyl Esters 67784-809 40-60 Non-Hazardous and Not Regulated
Glyceryl Monooleate 67701-32-0 3-8 Non-Hazardous and Not Regulated
67701-29-5
Proprietary ** 10-20 OSHA (PEL-TWA): NE
ACGIH (TLV-TWA): NE
Proprietary polymeric thickener ** 20-35

** Trade Secret,
On TSCA Inventory,
Not on the SARA Title III Sec 313 List

SECTION III - PHYSICAL DATA

Boiling Point: NE Melting Point: NA
Evap. Rate: Not Determined Specific Gravity: 0.92
Volatile: NE Solubility in H2O:NE
Appearance: Light tan clear liquid Freezing Point: NE
Vapor Pressure: NE

SECTION IV - FIRE AND EXPLOSIVE DATA

Flash Point: Above 150??C
Flammable Limit:Lower, NE; Upper, NE
Autoignition Temp: NE
Extinguishing Media: Water-fog, CO2, dry chemical and foam
Special Fire Fighting Procedures: Use self-contained breathing apparatus
Unusual Fire and Explosion Hazards: Rags soaked with any fluid present a fire hazard and should always be
stored in UL listed or Factory Mutual approved, covered containers. Improperly stored
rags can create conditions that lead to oxidation. Oxidation, under certain conditions
can lead to spontaneous combustion. This product contains antioxidants to retard
oxidation.
SECTION V - REACTIVITY DATA

Stability: Stable
Conditions Contributing to Instability: NA
Incompatibility: Avoid contact with strong oxidizers. Contact with these materials may result in the generation of
heat or a violent chemical reaction.
Hazardous Decomposition Thermal and Other:
Thermal - Oxides of carbon, nitrogen and phosphorus
Conditions to Avoid: NA
MSDS ?? DESIGREEN 215B
SECTION VI - TOXICITY

- Oral: Mixture has not been tested (NE).

- Dermal: NE
- Inhalation: NE
- Toxic Effect / Route of Entry
Eye Effects: Irritant
Skin Effects: Irritant
Prolonged contact may cause skin irritation.
- Other Toxic Effects: Inhalation of mists from this product can cause respiratory tract irritation.
- Target Organ Toxin: Eyes, skin and respiratory tract.
- Toxicity Comments: This product does not contain any carcinogens as listed by IARC, NTP., or OSHA.

SECTION VII - HEALTH HAZARD INFORMATION

- Permissible Exposure Limits: Permissible exposure limits have not been established for this product.
- Emergency First Aid: Don??t induce vomiting, give plenty of water, and get medical attention.
- Dermal: Wash with soap and water, remove contaminated clothing and launder. If redness or irritation
persists, get medical attention.
- Eye Contact: Flush with plenty of water, for at least 15 minutes; hold eyelids open while flushing; get medical
attention.
- Inhalation: Remove to fresh air.

SECTION VIII - SPECIAL PROTECTION INFORMATION

- Ventilation Requirements: Local exhaust - use with adequate ventilation. Investigate engineering techniques
to reduce exposure below airborne exposure limits. Provide ventilation of necessary to control exposure
levels below airborne exposure limits. Refer to the exposure limits of components in this product. If
practical, use local mechanical exhaust ventilation at source of air contamination such as open mixing
equipment.
- Eye: Goggles
- Hand (glove type): Any non-permeable type product
- Respiratory type: Filters (Mist)
Respiratory protection is normally not needed unless working conditions result in the generation of mists
from this product or solutions of this product. If mists are present, use NIOSH/MSHA approved dust/mist
masks, such as the 3M 8710 or 8715 particulate respirator. Appropriate eye protection must be worn
when using dust/mist masks.
- Other Protection Equipment: NA

SECTION IX - SPECIAL HANDLING AND STORAGE CONDITIONS

- Wash thoroughly after handling; do not get in eyes, on skin or clothing; don??t breath dust, vapor, mist or gas.
- Keep container closed.
- Empty contain may contain hazardous residues.

SECTION X - SPILL MANAGEMENT

- Absorb with sand or inert material; sweep or scoop up and remove; prevent spread of spill; dispose of
immediately.
SECTION XI - DISPOSAL PROCEDURES

- Consult federal, state or local authorities for proper disposal procedures.

MSDS ?? DESIGREEN 215B
NA - NOT APPLICABLE NE - NOT ESTABLISHE ____________________________________________________________________________________________

THE ABOVE INFORMATION IS ACCURATE TO THE BEST OF OUR KNOWLEDGE. HOWEVER, SINCE DATA, SAFETY
STANDARDS, AND GOVERNMENT REGULATIONS ARE SUBJECT TO CHANGE AND THE CONDITIONS OF HANDLING AND USE,
OR MISUSE, ARE BEYOND OUR CONTROL, DESILUBE TECHNOLOGY MAKES NO WARRANTY, EITHER EXPRESS OR IMPLIED,
WITH RESPECT TO THE COMPLETENESS OR CONTINUING ACCURACY OF THE INFORMATION CONTAINED HEREIN AN DISCLAIMS ALL LIABILITY FOR RELIANCE THEREON. USER SHOULD SATISFY HIMSELF THAT HE HAS ALL CURRENT DATA
RELEVANT TO HIS PARTICULAR USE.

;