Phosphoric acid,monobutyl ester
DoALL Cutting Fluids
1228-H Harding Avenue
Des Plaines, IL 60016
Phone: 847/803-7262 ?? Fax: 847/803-1447
MATERIAL SAFETY DATA SHEET
==============================================================================
MS218 Kleen Kool? 777
==============================================================================
PRODUCT NAME: Kleen Kool? 777
PRODUCT CLASS: HEAVY DUTY SYNTHETIC CUTTING FLUI
=== SECTION I MANUFACTURER IDENTIFICATION ==============
MANUFACTURER'S NAME: DoALL COMPANY
ADDRESS: 254 No. Laurel Ave. Des Plaines, IL 60016.
EMERGENCY PHONE: (800) 535-5053 (INFOTRAC)
INFORMATION: (847) 803-7262
REVISION DATE: April 2, 2004
=== SECTION II HAZARDOUS INGREDIENTS IDENTIFICATION ==============
OCCUPATIONAL EXPOSURE LIMITS
INGREDIENTS: CAS #: OSHA PEL: ACGIH TLV: PERCENT:
Polyalkylene
Glycol 9038-95-3 N.E. N.E. 5.0-10.0%
Triethanolamine 102-71-6 5 mg./cu. m. 5 mg./cu. m. 10.0-15.0%
Butyl Acid
Phosphate 1623-15-0 N.E. N.E. 1.0-3.0%
=== SECTION III PHYSICAL DATA ==============
212 ??F
Boiling Point:
Specific Gravity : 1.062 Water = 1)
Vapor Pressure: N
Melting Point: NA
Vapor Density: N
Evaporation Rate: ND (BuAc = 1)
Solubility in Water: Soluble
pH: 9.4 (@ 5%)
Appearance: Amber Liquid
Odor: Mild and sweet
=== SECTION IV FIRE AND EXPLOSION DATA ==============
FLASH POINT: NA
EXTINGUISHING MEDIA: Carbon Dioxide, Foam, or Dry Chemical.
FIRE FIGHTING PROCEDURES: Water stream or spray, to cool containers to prevent vapor formation
and ignition, may spread fire. Fog nozzles are preferred if water is
used. Wear SCBA gear in fire area.
UNUSUAL FIRE AN
EXPLOSION HAZARDS: None.
===============================================================================
MS218 Kleen Kool? 777
===============================================================================
=== SECTION V HEALTH HAZARD DATA ===============
ROUTES OF EXPOSURE AND EFFECTS OF OVER-EXPOSURE:
INHALATION: Minor breathing difficulty.
EYE CONTACT: Minor irritation.
SKIN CONTACT: Defatting, and/or minor irritation.
SKIN ABSORPTION: Not expected to occur.
INGESTION: Nausea, and/or diarrhea.
CARCINOGENICITY:
LISTED BY NTP: No.
LISTED BY IARC: No.
LISTED BY OSHA: No.
EMERGENCY FIRST AID PROCEDURES:
INHALATION: Remove person to fresh air. Get Medical attention.
EYE CONTACT: Flush with water for 15 minutes. If irritation persists, get Medical attention.
SKIN CONTACT: Wash exposed area with mild soap and warm water only. Do not use harsh soap or
solvent.
SKIN ABSORPTION: Get Medical attention.
INGESTION: Keep person warm and quiet. Get Medical attention. Do not induce vomiting.
=== SECTION VI REACTIVITY DATA ==============
STABILITY: Stable.
INCOMPATIBILITY: Strong oxidizers.
HAZARDOUS DECOMPOSITION PRODUCTS: None
HAZARDOUS POLYMERIZATION: Will not occur.
=== SECTION VII HANDLING PRECAUTIONS ==============
IN CASE OF ACCIDENTAL RELEASE:
SMALL SPILLS: Use absorbent material.
LARGE SPILLS: Dike and pump into drums.
RESIDUE: Mop with soap and water.
WASTE DISPOSAL METHOD: Treat as a chemical waste and dispose of in accordance with all local, state, and
federal regulations.
STORAGE: Store dry in a closed container in a cool place away from any fire source.
OTHER PRECAUTIONS: Practice good industrial hygiene. Use safety glasses and gloves when handling
the coolant concentrate.
=== SECTION VIII PROTECTIVE MEASURES ==============
VENTILATION: General mechanical ventilation should be adequate.
PROTECTIVE GLOVES: The use of NEOPRENE gloves or barrier cream is suggested.
EYE PROTECTION: Safety glasses with side shields or face shield are recommended.
OTHER PROTECTION: An emergency shower and eyewash should be available in the work area.
Practice reasonable personal hygiene. Wash exposed skin with mild soap and
warm water only. Product-soaked clothing should be changed promptly and
laundered before re-wearing.
===============================================================================
MS218 Kleen Kool? 777
===============================================================================
=== SECTION IX REGULATION COMPLIANCE INFORMATION ==============
CAA: Contains no ozone depleting substance.
DOT: Not classified as hazardous.
RCRA: As received, not a hazardous waste material.
SARA: No ingredients are listed.
TSCA: All ingredients are registered.
VOC:
EINECS: All of the components of Kleen Kool 777 are listed on the EINECS inventory.
=== SECTION X HMIS ==============
HEALTH: 1
FLAMMABILITY: 0
REACTIVITY: 0
===============================================================================
===============================================================================
Abbreviations and Symbols used in this MSDS:
NA - Not Applicable < - Less Than
ND - Not Determined > - Greater Than
BuAc - Butyl Acetate
===============================================================================
Data in this MSDS is believed to be correct and reliable. However, The DoALL Co. does not assume
responsibility for it, or any recommendations contained in it, inasmuch as conditions and methods of use
are beyond our control. Further, we make no warranty, expressed or implied, of any kind regarding this
product or its use, and purchaser assumes all risks of use or handling either in accordance with directions
or not.
The information contained within this document is property of DoALL Cutting Fluids. Alteration to this document
in any form is against the law. While the information released from DoALL Cutting Fluids is accurate and up to
date, we cannot protect from unlawful editing and changing of the information. We cannot guarantee any
information unless it is received directly from DoALL Cutting Fluids. We accept no responsibility for what
happens to this information once it leaves our offices. Please only trust information received directly from DoALL.
===============================================================================
;
Recommended suppliers
China (Mainland)
Assessed Supplier
butyl dihydrogen phosphate
- Assay:Pharmaceutical grade,
- Appearance:Powder
- Package:According to customer requirements
- Storage:dry and cool
- Transportation:Air and sea transportation
- Application:Pharmaceutical Industry
Contact Supplier
China (Mainland)
Assessed Supplier
Phosphoric acid,monobutyl ester
- Assay:Industrial Grade,
- Appearance:detailed see specifications
- Package:according to the clients requirement
- Storage:Store in dry, dark and ventilated place.
- Transportation:by air or by sea
- Application:Used in Synthesis, Pharmaceuticals and other fields
Contact Supplier
China (Mainland)
Assessed Supplier
butyl dihydrogen phosphate CAS:1623-15-0
- Assay:Pharmaceutical grade,
- Appearance:liquid
- Package:Inside plastic outside
- Storage:Inert atmosphere,Room Temperature
- Transportation:We ship goods via DHL, Fedex, UPS, TNT, China post, NL Post and other couriers, weight from 10g to 1000kg or even bulker
- Application:A commonly used organic chemical solvent, widely applied in the fields of medicine, chemical engineering, etc.
Contact Supplier
China (Mainland)
Assessed Supplier
Manufacturer supply CAS 1623-15-0 with best quality
- Assay:98%,99%,
- Appearance:White powder
- Package: [Packaging]20mg, 50mg,100mg,1g,10g,100g,according to customers' requirements
- Storage: should be stored in a well-closed container at low temperature, keep away from moisture, heat and light.
- Transportation:1. Samples 1kg-10kg are shipped by international express.
2. 50kg-100kg of goods are transported by dedicated line logistics.
3. Cargo 100kg-1ton is transported by dedicated line logistics.
- Application:Chemical raw materials, pharmaceutical intermediates, cosmetic raw materials, etc.
Contact Supplier
China (Mainland)
Assessed Supplier
Phosphoric acid,monobutyl ester
- Assay:99%
- Appearance:
- Package:drum
- Storage:
- Transportation:By Sea/Air/DHL
- Application:chemical
Contact Supplier