information Related products Suppliers

Jayfloc 803

Thermo Technologies, L.L.C. U.S. Department of Labor
Material Safety Data Sheet Occupational Safety and Health Administration
May be used to comply with OSHA??s Hazard (Non-Mandatory Form)
Communication Standard, 29 CFR 1910.1200. Form Approved
Standards must be consulted for specific requirements. OMB No. 1218-0072

Identity (As used on Label and List) Note: Blank Spaces are not permitted. If any item is not
Thermo-Gel? 200L applicable, or no information is available, the space must
be marked to indicate that.

Emergency Telephone Number:
Section I (800) 424-9300
Distributor??s Name and Address Telephone Number for Information:
(701) 258-8208
Thermo Technologies, L.L.C. Date prepared: NA = Not Applicable
400 East Broadway Suite 50 8/18/05 NE = Not Established
Bismarck, ND 58501 Signature of Preparer (optional) NH = Non-Hazardous

Section II ?? Hazardous Ingredients/Identity Information Serial Number 0485-1
Hazardous Components (Specific Other Limits
Chemical Identity; Common Name (s)) OSHA PEL ACGHI TLV Recommended % (Optional)
NE NE Irritant (eye) 20-30
Polyacrylate Polymer
CAS No. 25987-30-8

Petroleum hydrocarbon 5 mg/m3* 5 mg/m3* *(Oil mist in air) 20-30
CAS No. 6472-55-8

Surfactant NE NE Irritant (eye, skin) 1-5
CAS No. 9016-45-9
The final components of this product are listed in the US TSCA Chemical Substance Inventory. This product is not
transport regulated.
SARA Section 313 Reportable Toxic Chemicals ?? NONE%

Section III ?? Physical/Chemical Characteristic
Boiling Point Initial 96??C Specific gravity (H2O=1) Approx. 1.05
Vapor Pressure (mm Hg.) Not established NE Melting Point Not established NE
Vapor Density (Air=1) Not established NE Evaporation Rate Not established NE
(Butyl Acetate =1)

Solubility in Water Emulsifies in water with some soluble components present.
Appearance and Odor White opaque liquid with mild odor of hydrocarbon.

Section IV ?? Fire and Explosion Hazard Data
Flash Point (Method Used) Greater than 100??C (components summary) Flammable Limit LEL NE UEL NE

Extinguishing Media Water fog, CO2, dry chemical extinguishments.

Special Fire Fighting Procedures Use water fog. Avoid water jet/stream. Use self-contained breathing apparatus
and protective gear for any hostile fire. Spilled product creates slippery
conditions.

Unusual Fire and Explosion Hazards Petroleum hydrocarbon component, although formulated to prevent separation, if
separated can burn. Its flash point is in the range of 265??F (method: Cleveland
Open Cup).

Reproduced Locally Thermo-Gel? 200L 08/18/05 Serial No. 0485-1

Section V ?? Reactivity Data
Stability Unstable Conditions to Avoid None known.
X Stable

Incompatibility (Material to Avoid) Strong oxidizers, strong acids.

Hazardous Decomposition or Byproducts On thermal decomposition, oxides of carbon and nitrogen.

Hazardous May Occur Conditions to Avoid None known.
Polymerization X Will not Occur

Section VI ?? Health Hazard Data
Routes of Entry Inhalation: Yes Skin: Yes Ingestion: No

Health Hazards Components, surfactants will irritate the eyes and skin. Wear safety goggles when handling
(Acute and Chronic) concentrate. Irritation of the mucous membranes may result from inhalation of vapors/mist
forms.

Carcinogenicity NTP: No IARC: No OSHA: No

Signs and Symptoms of Exposure Reddening, swelling of the affected area with burning, itching or other discomfort.

Medical Conditions Generally Not confirmed. Existing cuts, rashes, allergies and other sensitive areas.
Aggravated by Exposure Respiratory disorder may be aggravated.

Emergency and First Aid Procedures Eyes: flush thoroughly with water. Skin: wash with soap and water.
Inhalation: move to fresh air. Ingestion: If ill effects occur, get medical attention.
For any continued discomfort/discoloration get professional medical attention.

Section VII ?? Precautions for Safe Handling and Use
Steps in Case of Contain. Wear protective gear. Collect, using suitable absorbent if needed. Flush residuals to the drain
Released/Spill for normal biological wastewater treatment. Put collected material into suitable containers for proper
disposal. Exercise caution in spill area as spilled material creates very slippery conditions.

Waste Disposal Incinerate according to applicable regulations. Diluted liquid form may be flushed with water to
Method normal wastewater treatment in accordance with Local, State/Provincial and Federal regulations.

Precautions to be Contains surfactants, handle as eye and skin irritant. Gloves and goggles are recommended when
Taken in Handling/ handling the concentrate. Avoid inhalation of vapors/mist forms. Do not ingest.
Storage

Other Precautions Exercise caution with spilled product as very slippery conditions, especially in contact with water,
are created. Prevent release of concentrate to waterways.

Section VIII ?? Control Measures
Respiratory Protection Not required for normal product end use. Observe any Section II MSDS exposure limits.

Ventilation Local Exhaust Ensure vapors/mist forms are removed. Special Not required.

Mechanical Recommended Other Ventilation Not required.

Protective Gloves Impervious neoprene or rubber. Eye Protection Safety goggles.

Other Protective Apron, shoes, or other to prevent Work/Hygienic Wash thoroughly after handling.
Clothing or Equipment skin contact. Practices

;