Carbitol Carbitol SolventLow Diethylene glycol ethyl ether
SAFETY DATA SHEETS
According to the UN GHS revision 10
Version: 1.0
Creation Date: July 15, 2019
Revision Date: July 15, 2019
Product name |
2-(2-ethoxyethoxy)ethanol |
---|
Product number |
- |
---|---|
Other names |
2(2-Ethoxyethoxy)ethanol; Dioxitol; CARBITOL |
Identified uses |
Industrial and scientific research use. |
---|---|
Uses advised against |
no data available |
Not classified.
Pictogram(s) | No symbol. |
---|---|
Signal word |
No signal word |
Hazard statement(s) |
none |
Precautionary statement(s) | |
Prevention |
none |
Response |
none |
Storage |
none |
Disposal |
none |
no data available
Chemical name | Common names and synonyms | CAS number | EC number | Concentration |
---|---|---|---|---|
2-(2-ethoxyethoxy)ethanol | 2-(2-ethoxyethoxy)ethanol | 111-90-0 | 203-919-7 | 100% |
If inhaled
Fresh air, rest.
Following skin contact
Remove contaminated clothes. Rinse skin with plenty of water or shower.
Following eye contact
First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then refer for medical attention.
Following ingestion
Rinse mouth.
None expected. (USCG, 1999)
Minimum/Potential Fatal Human Dose
It has been estimated that the single oral dose /of diethylene glycol/ lethal for humans is approximately 1 ml/kg. Diethylene glycols
Absorption, Distribution and Excretion
To assist evaluation of the hazards of skin contact with selected undiluted glycol ethers, their absorption across isolated human abdominal epidermis was measured in vitro. Epidermal membranes were set up in glass diffusion cells and, following an initial determination of permeability to tritiated water, excess undiluted glycol ether was applied to the outer surface for 8 hr. The appearance of glycol ether in an aqueous receptor phase bathing the underside of the epidermis was quantified by a gas chromatographic technique. A final determination of tritiated water permeability was compared with initial values to establish any irreversible alterations in epidermal barrier function induced by contact with the glycol ethers. 2-methoxyethanol (EM) was most readily absorbed (mean steady rate 2.82 mg/sq cm/hr), and a relatively high absorption rate (1.17 mg/sq cm/hr) was also apparent for 1-methoxypropan-2-ol (PM). There was a trend of reducing absorption rate with increasing molecular weight or reducing volatility for monoethylene glycol ethers (EM, 2.82 mg/sq cm/hr; 2-ethoxyethanol, EE, 0.796 mg/sq cm/hr; 2-butoxyethanol, EB, 0.198 mg/sq cm/hr) and also within the diethylene glycol series: 2-(2-methoxyethoxy) ethanol (DM, 0.206 mg/sq cm/hr); 2-(2-ethoxyethoxy) ethanol (DE, 0.125 mg/sq cm/hr) and 2-(2-butoxyethoxy) ethanol (DB, 0.035 mg/sq cm/hr). The rate of absorption of 2-ethoxyethyl acetate (EEAc) was similar to that of the parent alcohol, EE. Absorption rates of diethylene glycol ethers were slower than their corresponding monoethylene glycol equivalents. Combination of intrinsic toxicity and ability to pass across skin contribute to assessment of hazards of contact with undiluted glycol ethers.[Dugard PH et al; Environ Health Perspect 57: 193-7 (1984)] Full text: PMC1568269
If material on fire or involved in fire: Use water in flooding quantities as fog. Cool all affected containers with flooding quantities of water. Apply water from as far a distance as possible. Use "alcohol" foam, dry chemical or carbon dioxide. Keep run-off water out of sewers and water sources.
This chemical is combustible. (NTP, 1992)
Use water spray, powder, alcohol-resistant foam, carbon dioxide.
Collect leaking liquid in sealable containers. Wash away remainder with plenty of water.
Collect leaking liquid in sealable containers. Wash away remainder with plenty of water.
Collect and arrange disposal. Keep the chemical in suitable and closed containers for disposal. Remove all sources of ignition. Use spark-proof tools and explosion-proof equipment. Adhered or collected material should be promptly disposed of, in accordance with appropriate laws and regulations.
NO open flames. Above 96°C use a closed system and ventilation. Handling in a well ventilated place. Wear suitable protective clothing. Avoid contact with skin and eyes. Avoid formation of dust and aerosols. Use non-sparking tools. Prevent fire caused by electrostatic discharge steam.
Separated from strong oxidants. Ventilation along the floor.
Occupational Exposure limit values
MAK: (inhalable fraction): 50 mg/m3; peak limitation category: I(2); pregnancy risk group: C
Biological limit values
no data available
Ensure adequate ventilation. Handle in accordance with good industrial hygiene and safety practice. Set up emergency exits and the risk-elimination area.
Eye/face protection
Wear safety spectacles.
Skin protection
Protective gloves.
Respiratory protection
Use ventilation.
Thermal hazards
no data available
Physical state |
Liquid. |
---|---|
Colour |
Colourless. |
Odour |
Mild, pleasant odor |
Melting point/freezing point |
-54 °C. Atm. press.:1 atm. |
Boiling point or initial boiling point and boiling range |
196 °C. Atm. press.:1 atm. |
Flammability |
Combustible. |
Lower and upper explosion limit/flammability limit |
Lower flammable limit: 1.2% by volume; Upper flammable limit: 23.5% AT 360 DEG F (182 DEG C) by volume |
Flash point |
96 °C. Atm. press.:1 atm. |
Auto-ignition temperature |
204 °C. Atm. press.:1 atm. |
Decomposition temperature |
no data available |
pH |
no data available |
Kinematic viscosity |
dynamic viscosity (in mPa s) = Ca. 3.85. Temperature:25.0°C. |
Solubility |
greater than or equal to 100 mg/mL at 68° F (NTP, 1992) |
Partition coefficient n-octanol/water |
log Pow = -0.54. Temperature:20 °C. |
Vapour pressure |
0.126 mm Hg. Temperature:25 °C. Remarks:Information attributed to Daubert and is an estimate. |
Density and/or relative density |
Ca. 988.5 kg/m³. Temperature:20 °C. |
Relative vapour density |
4.63 (vs air) |
Particle characteristics |
no data available |
Reacts with strong oxidants. The substance can presumably form explosive peroxides.
no data available
CombustibleMixing diethylene glycol monoethyl ether in equal molar portions with any of the following substances in a closed container caused the temperature and pressure to increase: chlorosulfonic acid and oleum, NFPA 1991.
no data available
Can react with oxidizing materials.
When heated to decomposition it emits acrid smoke and irritating fumes.
Acute toxicity
Skin corrosion/irritation
no data available
Serious eye damage/irritation
no data available
Respiratory or skin sensitization
no data available
Germ cell mutagenicity
no data available
Carcinogenicity
no data available
Reproductive toxicity
no data available
STOT-single exposure
The substance is mildly irritating to the eyes.
STOT-repeated exposure
The substance defats the skin, which may cause dryness or cracking.
Aspiration hazard
No indication can be given about the rate at which a harmful concentration of this substance in the air is reached on evaporation at 20°C.
AEROBIC: Aerobic biological screening studies, which utilized settled wastewater, sewage, or activated sludge for inocula, indicate that diethylene glycol monoethyl ether should biodegrade rapidly in the environment following an acclimation period(1-6). After a 16 day acclimation period a 39.8% BODT was recorded using an 8 hr Warburg test(5). A 5 day BOD test at 20 deg C showed a 34.3% loss after 16 days of acclimation(5). A second 5 day BOD test, utilizing an adapted seed inoculum exhibited a 30% BODT(1). Incubation of diethylene glycol monoethyl ether for 5, 10, and 20 days without an acclimation period resulted in BOD values, measured in % theoretical, of 5, 31, and 48, respectively(2). Diethylene glycol monoethyl ether, inoculated with wastewater, was bio-oxidized 17, 71, 75, and 87% following 5, 10, 15, and 20 days incubation, respectively; in seawater, this compound was bio-oxidized 11, 44, 57, and 70% in 5, 10, 15, and 20 days, respectively(3). According to the Zahn-Wellens screening method >90% loss of 400 ppm occurred in 28 days(4). A study using activated sludge gave a degradation rate for diethylene glycol monoethyl ether of 0.18/hour(6) giving a half-life of 3.9 hours(SRC).
An estimated BCF of 3 was calculated in fish for diethylene glycol monoethyl ether(SRC), using a log Kow of -0.54(1) and a regression-derived equation(2). According to a classification scheme(3), this BCF suggests the potential for bioconcentration in aquatic organisms is low(SRC).
The Koc of diethylene glycol monoethyl ether is estimated as 12(SRC), using a log Kow of -0.54(1) and a regression-derived equation(2). According to a classification scheme(3), this estimated Koc value suggests that diethylene glycol monoethyl ether is expected to have very high mobility in soil.
no data available
Product
The material can be disposed of by removal to a licensed chemical destruction plant or by controlled incineration with flue gas scrubbing. Do not contaminate water, foodstuffs, feed or seed by storage or disposal. Do not discharge to sewer systems.
Contaminated packaging
Containers can be triply rinsed (or equivalent) and offered for recycling or reconditioning. Alternatively, the packaging can be punctured to make it unusable for other purposes and then be disposed of in a sanitary landfill. Controlled incineration with flue gas scrubbing is possible for combustible packaging materials.
ADR/RID: Not dangerous goods. (For reference only, please check.) | IMDG: Not dangerous goods. (For reference only, please check.) | IATA: Not dangerous goods. (For reference only, please check.) |
ADR/RID: Not dangerous goods. (For reference only, please check.) | IMDG: Not dangerous goods. (For reference only, please check.) | IATA: Not dangerous goods. (For reference only, please check.) |
ADR/RID: Not dangerous goods. (For reference only, please check.) | IMDG: Not dangerous goods. (For reference only, please check.) | IATA: Not dangerous goods. (For reference only, please check.) |
ADR/RID: Not dangerous goods. (For reference only, please check.) | IMDG: Not dangerous goods. (For reference only, please check.) | IATA: Not dangerous goods. (For reference only, please check.) |
ADR/RID: No | IMDG: No | IATA: No |
no data available
no data available
Chemical name | Common names and synonyms | CAS number | EC number |
---|---|---|---|
2-(2-ethoxyethoxy)ethanol | 2-(2-ethoxyethoxy)ethanol | 111-90-0 | 203-919-7 |
European Inventory of Existing Commercial Chemical Substances (EINECS) | Listed. | ||
EC Inventory | Listed. | ||
United States Toxic Substances Control Act (TSCA) Inventory | Listed. | ||
China Catalog of Hazardous chemicals 2015 | Not Listed. | ||
New Zealand Inventory of Chemicals (NZIoC) | Listed. | ||
Philippines Inventory of Chemicals and Chemical Substances (PICCS) | Listed. | ||
Vietnam National Chemical Inventory | Listed. | ||
Chinese Chemical Inventory of Existing Chemical Substances (China IECSC) | Listed. | ||
Korea Existing Chemicals List (KECL) | Listed. |
Information on revision
Creation Date | July 15, 2019 |
---|---|
Revision Date | July 15, 2019 |
Abbreviations and acronyms
Package&Shipping
Qingdao Bravery International Trading Co., LTD. is located in the beautiful tourist city of Qingdao, is a comprehensive chemical enterprise which doing import and export business. Product range including, API, pharmacy intermediates,food additive,Surfactant ,fungicides and other general chemicals. etc.
With the developing world market, we adhere to the principle of "quality, service, integrity and development" ,Forge ahead,and constantly in pursuit of higher level of product quality and service.
We warmly welcome customers home and abroad to build mutual trust, mutual benefit and stable cooperation relation.
General items: import and export of goods; Technology import and export; Food additive sales; Feed additive sales; Sales of special chemical products (without hazardous chemicals); Sales of chemical products (excluding licensed chemical products); Livestock and fishery feed sales; Feed raw material sales; Fertilizer sales; Sales of bio-based materials; Health food (pre-packaged) sales; Food sales (pre-packaged food only); Sales of agricultural and sideline products; Pharmaceutical excipients sales; Drug wholesale
We could give you:
1.Best quality in your requirement
2.Competitive price in China market with standard high quality or customize
3.mature Technical support,Well-trained and professional technologist and sales with rich experience in the field for 5-10 years
4.Professional logistic support,Free sample and correct shipping documents dispatched according to regulations of different countries
All we want is win-win business. Send your inquiries, you will get it!
Why choose us:
1.Factory direct sales, so we can provide the competitive price and high quality product base on 5 years of production and R&D experience
2.It is available in stock for quick shipment. Products could be packaged according to customer’s specialized requirements.
3.The products can be transported by Courier, air or sea.
4.Customers will receive the most professional technical support and efficient service.
5.Any inquiries will be replied within 24hours.
6.High purity with test report.
CAS NO:82451-48-7
CAS NO:129757-67-1
CAS NO:106990-43-6
CAS NO:70624-18-9
CAS NO:52829-07-9
CAS NO:65447-77-0
About|Contact|Cas|Product Name|Molecular|Country|Encyclopedia
Message|New Cas|MSDS|Service|Advertisement|CAS DataBase|Article Data|Manufacturers | Chemical Catalog
©2008 LookChem.com,License: ICP
NO.:Zhejiang16009103
complaints:service@lookchem.com Desktop View