(S)-alpha-amino-1H-Imidazole-4-propanoic acid Histidinum [INN-Latin] alpha-Amino-4(or 5)-imidazolepropionic acid
Chemical Safety Data Sheet MSDS / SDS
Revision Date:2024-08-24Revision Number:1
Hazard statement(s)
none
Prevention
none
Response
none
Storage
none
Disposal
none
If inhaled
After inhalation: fresh air.
In case of skin contact
In case of skin contact: Take off immediately all contaminated clothing. Rinse skin with water/ shower.
In case of eye contact
After eye contact: rinse out with plenty of water. Remove contact lenses.
If swallowed
After swallowing: make victim drink water (two glasses at most). Consult doctor if feeling unwell.
The most important known symptoms and effects are described in the labelling (see section 2.2) and/or in section 11
No data available
Suitable extinguishing media
Water Foam Carbon dioxide (CO2) Dry powder
Unsuitable extinguishing media
For this substance/mixture no limitations of extinguishing agents are given.
Carbon oxides, Nitrogen oxides (NOx) Combustible.
Development of hazardous combustion gases or vapours possible in the event of fire.
In the event of fire, wear self-contained breathing apparatus.
Suppress (knock down) gases/vapors/mists with a water spray jet. Prevent fire extinguishing water from contaminating surface water or the ground water system.
1
0
0
HEALTH | 1 | Exposure would cause irritation with only minor residual injury (e.g. acetone, sodium bromate, potassium chloride) | |
FIRE | 0 | Materials that will not burn under typical fire conditions, including intrinsically noncombustible materials such as concrete, stone, and sand. Materials that will not burn in air when exposed to a temperature of 820 °C (1,500 °F) for a period of 5 minutes.(e.g. Carbon tetrachloride) | |
REACT | 0 | Normally stable, even under fire exposure conditions, and is not reactive with water (e.g. helium,N2) | |
SPEC. HAZ. |
Advice for non-emergency personnel: Avoid inhalation of dusts. Evacuate the danger area, observe emergency procedures, consult an expert.
For personal protection see section 8.
Do not let product enter drains.
Cover drains. Collect, bind, and pump off spills. Observe possible material restrictions (see sections 7 and 10). Take up dry. Dispose of properly. Clean up affected area. Avoid generation of dusts.
For disposal see section 13.
For precautions see section 2.2.
Tightly closed. Dry.
Apart from the uses mentioned in section 1.2 no other specific uses are stipulated
Hazard composition and occupational exposure limits
Does not contain substances with occupational exposure limits.
Appropriate engineering controls
Change contaminated clothing. Wash hands after working with substance.
Personal protective equipment
Eye/face protection
Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU). Safety glasses
Skin protection
Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique (without touching glove's outer surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands.
The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it.
Full contact
Material: Nitrile rubber
Minimum layer thickness: 0,11 mm Break through time: 480 min
Material tested:Dermatril? (KCL 740 / Aldrich Z677272, Size M)
Splash contact Material: Nitrile rubber
Minimum layer thickness: 0,11 mm Break through time: 480 min
Material tested:Dermatril? (KCL 740 / Aldrich Z677272, Size M)
data source: KCL GmbH, D-36124 Eichenzell, phone +49 (0)6659 87300, e-mail sales@kcl.de, test method: EN374
If used in solution, or mixed with other substances, and under conditions which differ from EN 374, contact the supplier of the EC approved gloves. This recommendation is advisory only and must be evaluated by an industrial hygienist and safety officer familiar with the specific situation of anticipated use by our customers. It should not be construed as offering an approval for any specific use scenario.
Respiratory protection
required when dusts are generated.
Our recommendations on filtering respiratory protection are based on the following standards: DIN EN 143, DIN 14387 and other accompanying standards relating to the used respiratory protection system.
Control of environmental exposure
Do not let product enter drains.
No data available
The following applies in general to flammable organic substances and mixtures: in correspondingly fine distribution, when whirled up a dust explosion potential may generally be assumed.
The product is chemically stable under standard ambient conditions (room temperature) .
No data available
no information available
No data available
Hazardous decomposition products formed under fire conditions. - Carbon oxides, Nitrogen oxides (NOx)
Other decomposition products - No data available In the event of fire: see section 5
Acute toxicity
LD50 Oral - Rat - male and female - > 5.110 mg/kg (OECD Test Guideline 423)
Skin corrosion/irritationSerious eye damage/eye irritation
Eyes - In vitro study Result: No eye irritation (OECD Test Guideline 437)
Respiratory or skin sensitization
No data available
Germ cell mutagenicity
No data available
Carcinogenicity
IARC: No ingredient of this product present at levels greater than or equal to 0.1% is identified as probable, possible or confirmed human carcinogen by IARC.
Reproductive toxicity
No data available
Specific target organ toxicity - single exposure
No data available
Specific target organ toxicity - repeated exposure
No data available
Aspiration hazard
No data available
Additional Information
RTECS: MS3070000
To the best of our knowledge, the chemical, physical, and toxicological properties have not been thoroughly investigated.
Toxicity
LD50 orally in Rabbit: > 5110 mg/kg
Toxicity to daphnia and other aquatic invertebrates
static test EC50 - Daphnia magna (Water flea) - > 100 mg/l - 48 h (OECD Test Guideline 202)
Toxicity to algae
static test EC10 - Desmodesmus subspicatus (green algae) - 58 mg/l
- 72 h
(OECD Test Guideline 201)
static test NOEC - Desmodesmus subspicatus (green algae) - 10 mg/l
- 72 h
(OECD Test Guideline 201)
static test ErC50 - Desmodesmus subspicatus (green algae) - > 100 mg/l - 72 h
(OECD Test Guideline 201)
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
Discharge into the environment must be avoided.
See www.retrologistik.com for processes regarding the return of chemicals and containers, or contact us there if you have further questions.
ADR/RID: - IMDG: - IATA: -
ADR/RID: Not dangerous goods IMDG: Not dangerous goods IATA: Not dangerous goods
ADR/RID: - IMDG: - IATA: -
ADR/RID: - IMDG: - IATA: -
ADR/RID: no IMDG Marine pollutant: no IATA: no
Not classified as dangerous in the meaning of transport regulations.
Regulations on the Safety Management of Hazardous Chemicals
China Catalog of Hazardous chemicals 2015:Not Listed. website: #
Measures for Environmental Management of New Chemical Substances
Chinese Chemical Inventory of Existing Chemical Substances (China IECSC):Listed. website: #
EC Inventory:Listed.
European Inventory of Existing Commercial Chemical Substances (EINECS):Listed. website: #
Korea Existing Chemicals List (KECL):Listed. website: //ncis.nier.go.kr
New Zealand Inventory of Chemicals (NZIoC):Listed. website: #
Philippines Inventory of Chemicals and Chemical Substances (PICCS):Listed. website: #
United States Toxic Substances Control Act (TSCA) Inventory:Listed. website: #
Vietnam National Chemical Inventory:Listed. website: #
Package&Shipping
Qingdao Bravery International Trading Co., LTD. is located in the beautiful tourist city of Qingdao, is a comprehensive chemical enterprise which doing import and export business. Product range including, API, pharmacy intermediates,food additive,Surfactant ,fungicides and other general chemicals. etc.
With the developing world market, we adhere to the principle of "quality, service, integrity and development" ,Forge ahead,and constantly in pursuit of higher level of product quality and service.
We warmly welcome customers home and abroad to build mutual trust, mutual benefit and stable cooperation relation.
General items: import and export of goods; Technology import and export; Food additive sales; Feed additive sales; Sales of special chemical products (without hazardous chemicals); Sales of chemical products (excluding licensed chemical products); Livestock and fishery feed sales; Feed raw material sales; Fertilizer sales; Sales of bio-based materials; Health food (pre-packaged) sales; Food sales (pre-packaged food only); Sales of agricultural and sideline products; Pharmaceutical excipients sales; Drug wholesale
We could give you:
1.Best quality in your requirement
2.Competitive price in China market with standard high quality or customize
3.mature Technical support,Well-trained and professional technologist and sales with rich experience in the field for 5-10 years
4.Professional logistic support,Free sample and correct shipping documents dispatched according to regulations of different countries
All we want is win-win business. Send your inquiries, you will get it!
Why choose us:
1.Factory direct sales, so we can provide the competitive price and high quality product base on 5 years of production and R&D experience
2.It is available in stock for quick shipment. Products could be packaged according to customer’s specialized requirements.
3.The products can be transported by Courier, air or sea.
4.Customers will receive the most professional technical support and efficient service.
5.Any inquiries will be replied within 24hours.
6.High purity with test report.
About|Contact|Cas|Product Name|Molecular|Country|Encyclopedia
Message|New Cas|MSDS|Service|Advertisement|CAS DataBase|Article Data|Manufacturers | Chemical Catalog
©2008 LookChem.com,License: ICP
NO.:Zhejiang16009103
complaints:service@lookchem.com Desktop View